Nedap VP1004-B User manual

Instruction Manual
VP1004-B
Safety Instructions
5287782 / Version 01.000 / December 2019 / EN
Original instructions

Livestock Management

Copyright
Copyright © Nedap N.V. All rights reserved. The information in this document is subject to change without notice, it is
not to be reproduced in any way, in whole or in part, without the written consent of Nedap N.V. All trademarks
referenced belong to their respective owners.
Disclaimer
Nedap N.V. has made every effort to ensure the accuracy of the information contained in this document. However,
Nedap N.V. makes no representations or warranties whatsoever whether express or implied as to the accuracy,
correctness, completeness or fit-for-purpose or suitability for the purpose of this product.
You use the products at your own risk. Nedap N.V. excludes any liability to the maximum extent permitted by applicable
law for the damages caused by errors or failures made during the installation or improper use of this product or by not
applying the instructions stated in this document. Nedap N.V. reserves the right to make
improvements or amendments to this document and/or the products described therein at any time without any
notification. The latest version of this document can be found on the Nedap Livestock Management business portal
(www.nedap.com/livestockmanagement-portal). Please download the latest version of this document (by yourself or
reseller) and keep a copy for your own records. This document can be published in various languages but only the English
language version will prevail. Nedap N.V. assumes no responsibility for any errors caused for the translations into another
language.
Warranty and spare parts
Please consult the Nedap products dealer from whom you purchased this product, in regards to the applicable warranty
conditions. This product cannot be used for any other purpose as described in this document. If
the product is not installed according to this document; the warranty provided is not applicable. At the sole discretion
of Nedap N.V., Nedap N.V. may decide to change the conditions of the warranty policy. You agree that Nedap N.V. is
able to compensate you the pro-rata value of the warranty involved rather than replacing or repairing the product
depending on the technical or economical value of the product. Prior to applying the warranty, please verify if you
comply with the warranty conditions of the warranty policy, whether you can successfully apply for the replacement or
repair of a defective part. Parts can only be replaced with original
Nedap parts, otherwise the warranty policy will not be applicable on the product. If the warranty is applicable, please
contact the dealer or send the defective parts to the dealer.
Additional information
For any information or questions regarding the product, please contact your own dealer.
The installation manual for this product can be found at: www.nedap.com/livestockmanagement-portal

VP1004-B / Safety Instructions 5287782 /
Version 01.000 / December 2019 / EN
1
Livestock Management
1Safety
Read this manual before using this product. Failure to follow the instructions and safety precautions in this manual may
result in serious injury or death. Keep this manual in a safe location for future reference.
Symbols used in the manual
Danger Indicates a hazardous situation that, if not avoided, will result in death or serious injury.
Warning Indicates a hazardous situation that, if not avoided, could result in death or serious injury.
Caution Indicates a hazardous situation that, if not avoided, could result in minor or moderate injury.
Indicates important information but not hazard related.
Suggestions and advice to perform certain tasks more easily.
General safety instructions
Warning
Always turn off the mains power supply when working on the electrical installation.
Warning
Always wear proper protection when installing and maintaining the VP1004-B.
Caution
Use the VP1004-B only with a suitable power supply. The power supply or power adapter must comply with local
regulations for a SELV, limited power (NEC class2, ps2) output (e.g. Nedap VP2001-B or Nedap power adapter (P/N
9223126)).
Caution
Installation and service should only be done by locally qualified personnel.
Caution
Install the system according to the local rules and regulations.
Working environment
Caution
The installation area must be free from any obstacles, including animals.

VP1004-B / Safety Instructions 5287782 /
Version 01.000 / December 2019 / EN
2
Livestock Management
Caution
Make sure all components are installed out of reach of animals.
Caution
Make sure all cables are properly concealed, and form no danger for stumbling.
Caution
Take into account the high concentrations of ammonia when installing and maintaining the VP1004-B in pig barns.
Animal welfare and safety
The automated actions of the Nedap Livestock Management systems do never discharge the installer and the user of the
system from his/her responsibility to assure and to take care of the well-being of the animals.

VP1004-B / Safety Instructions 5287782 /
Version 01.000 / December 2019 / EN
3
Livestock Management
2Compliance
FCC and ISED Compliance statement
This device complies with part 15 of the FCC Rules and to RSS-210 of Innovation, Science and Economic Development
Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
Cet appareil se conforme aux normes RSS 210 exemptés de license d'Innovation, Sciences et Développement
économique Canada. L'opération est soumis aux deux conditions suivantes: (1) cet appareil ne doit causer aucune
interférence, et (2) cet appareil doit accepter n'importe quelle interférence, y inclus interférence qui peut causer une
operation non pas voulu de cet appareil.
Les changements ou modifications n'ayant pas été expressément approuvés par la partie responsable de la conformité peuvent
faire perdre à l'utilisateur l'autorisation de faire fonctionner le matériel.
FCC and ISED Radiation Exposure Statement
This equipment complies with FCC and Canadian radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 3 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme a RSS-102 limites énoncées pour un environnement non contrôlé. Cet équipement doit
être installé et utilisé avec une distance minimale de 3 cm entre le radiateur et votre corps.
FCC and ISED Information to the user
Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequent energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does not
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver.
This Class B digital apparatus complies with the Canadian standard ICES-003. Cet appareil numérique de Classe B est
conforme à la norme Canadienne ICES-003.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. To ensure compliance with FCC regulations, use only the shielded interface cables
provided with the product, or additional specified components or accessories that can be used with the installation of the
product.

VP1004-B / Safety Instructions
5287782 / Version 01.000 / December 2019 / EN LivestockManagement
4
Antennas
This device may be used with the following Nedap antennas: VP6011 and VP6012.
Disposal
The WEEE symbol in Europe indicates that the relevant electrical product or battery should not be disposed of as
general household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose them
in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries. In so doing, you
will help to conserve natural resources and improve standards of environmental protection in treatment and disposal of
electrical waste (Waste Electrical and Electronic Equipment Directive WEEE 2012/19/EU).
CE
Hereby NEDAP N.V. declares that the subject equipment is in compliance with the directives 2014/53/
EU (Radio Equipment Directive) and 2011/65/EU (Restriction of the use of certain hazardous substances). The full text
of the EU declaration of conformity is available at our Business Portal: http:
/
/
/
www.nedap.com/
livestockmanagement-portal.
Parallelweg 2
NL-7471 DC Groenlo
The Netherlands