Nedap SmartTag Ear Instruction manual

SmartTag Ear / Quick start manual
5288215 / Version 00.001 / November 2020 / EN
1
Dairy Farming
Quick start manual
SmartTag Ear
How to attach the SmartTag Ear
Put the SmartTag Ear and male part of the tag into the plier and attach to the cow's ear. Make sure the SmartTag Ear is
in the correct position in the ear:
• The SmartTag Ear should be on the front side of the ear.
• The Tag should be in the middle of the ear (not in the outside of the ear, in the auricle itself, or into any of the ear's
nerves).
• When there is already a tag in the ear, there should be no contact in any way between the tag and the SmartTag
Ear.

SmartTag Ear / Quick start manual
5288215 / Version 00.001 / November 2020 / EN
2
Dairy Farming
Figure1:Correct positions
Figure2:Wrong positions
Additional information

SmartTag Ear / Quick start manual
5288215 / Version 00.001 / November 2020 / EN
3
Dairy Farming
Technical specifications
SmartTag Ear
Item Specification
Electrical supply
Supply voltage Lithium coin cell 3,0 V (internal)
Antenna
Operating frequency (center) 433,3 - 434,5 MHz
Max. transmit power <1mW E.r.p.
Environmental
Operation temperature range -10 to 50 °C (14 to 122 °F)
Storage temperature range -20 to 70 °C (-4 to 158 °F)
Relative humidity (non-condensing) < 93% (non-condensing)
Protection against water and dirt IP67
Compliance
Certificates and declarations All relevant certificates and declarations are available at our Business Portal: http://
www.nedap.com/livestockmanagement-portal.
Compliance
Region [1] Certification
Europe
USA FCC ID: CGDFERPH
Canada IC: 1444A-FERPH
Australia
New-Zealand R-NZ
[1] All relevant certificates and declarations are available at our Business Portal: https://www.nedap.com/livestockmanagement-portal
FCC and ISED Compliance statement
This device complies with part 15 of the FCC Rules and with RSS-210 of Innovation, Science and Economic
Development Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Cet appareil se conforme aux normes CNR-210 exemptés de license d'Innovation, Sciences et Développement
économique Canada. L'opération est soumis aux deux conditions suivantes: (1) cet appareil ne doit causer aucune
interférence, et (2) cet appareil doit accepter n'importe quelle interférence, y inclus interférence qui peut causer une
operation non pas voulu de cet appareil.
Les changements ou modifications n'ayant pas été expressément approuvés par la partie responsable de la conformité
peuvent faire perdre à l'utilisateur l'autorisation de faire fonctionner le matériel.

Copyright and Disclaimer
Copyright © Nedap N.V., Parallelweg 2, NL-7141 DC Groenlo, The Netherlands. This document is property of Nedap N.V. and the
content is not to be reproduced in any way, in whole or in part, without the prior written consent of Nedap N.V. Nedap N.V. makes no
representations or warranties whether express or implied as to the accuracy, correctness, completeness of this document. If this
document is part of the installation manual, the installation manual will be leading. You use the products at your own risk. Nedap N.V.
reserves the right to make changes to this document and/or the products described. Please consult the Nedap Livestock Management
business portal (www.nedap.com/livestockmanagement-portal) for any changes or notification.
Parallelweg 2
NL-7141 DCGroenlo
The Netherlands
CE
Hereby NEDAP N.V. declares that the subject equipment is in compliance with the directives 2014/53/ EU (Radio
Equipment Directive) and 2011/65/EU (Restriction of the use of certain hazardous substances). The full text of the EU
declaration of conformity is available at our Business Portal: http://www.nedap.com/ livestockmanagement-portal.
Handling instructions
Storage
• If the product is to be stored for some time, make sure that it is under a protective cover to prevent dirt and
moisture from entering.
• Do not expose the product to direct sunlight and / or adverse weather conditions such as storm, rain, hail or snow.
• See Summary technical specifications for the storage temperature range and relative humidity.
Disposal
The owner or last user of the product is responsible for the proper disposal of (parts of) the product according to local
rules and regulations.
The WEEE symbol in Europe indicates that the relevant electrical product or battery should not be disposed of as
general household waste in Europe. To ensure the correct waste treatment of the product and battery, please dispose
them in accordance to any applicable local laws of requirement for disposal of electrical equipment or batteries. In so
doing, you will help to conserve natural resources and improve standards of environmental protection in treatment and
disposal of electrical waste (Waste Electrical and Electronic Equipment Directive WEEE 2012/19/EU).
Warranty and spare parts
Please consult the Nedap products dealer from whom you purchased this product, in regards to the applicable
warranty conditions. This product cannot be used for any other purpose as described in this document. If the product
is not installed according to this document; the warranty provided is not applicable. At the sole discretion of Nedap
N.V., Nedap N.V. may decide to change the conditions of the warranty policy. You agree that Nedap N.V. is able to
compensate you the pro-rata value of the warranty involved rather than replacing or repairing the product depending
on the technical or economical value of the product. Prior to applying the warranty, please verify if you comply with
the warranty conditions of the warranty policy, whether you can successfully apply for the replacement or repair
of a defective part. Parts can only be replaced with original Nedap parts, otherwise the warranty policy will not be
applicable on the product. If the warranty is applicable, please contact the dealer or send the defective parts to the
dealer.