Neo Chair DBS User manual

ASSEMBLY
INSTRUCTION
(-H)
BACK X1 SEAT X1 ARMREST X2
CONTROL
MECHANISM X1
WHEEL X5 BASE X1
BASE LEG X1
GAS LIFT
CYLINDER X1
X10
A
X2
E
X4
B
X10
C
X1
D
(SEAT + BACK
ARMREST)
(LOCKING)
(WASHER)
(ALLEN KEY)
※Please make sure all the parts are included.
Missing parts? [email protected]
HEAD REST X1 HEAD REST BOLT
Instructions
User Manual
Cautions
Contents
Read the instructions carefully. Please follow the assembly steps.
Cautions
To deodorize your new chair
leave the chair in a well
ventilated area for 1-2 days
For longer use
Re-tighten bolts every 6 months by using
the enclosed allen-key.
*Using an electric drill can damage the chair.
Please re-tighten bolts manually.
Use this product only for
seating one person at a time
Regularly check all bolts,
screws, and knobs are tight
Be careful, some of the part
are heavy and has sharped edge
Failure to follow these warnings
may cause serious injury
DO NOT use the chair
unless all bolts, screws
and knobs are tight
DO NOT use the chair if
only components are
missing or damaged
DO NOT stand on the chair
use as a step stool or ladder
[e-mail]
www.neochair.com
Our goal is to create a perfect customer experience.
Let us know if you have any feedback.
Your comment motivates us to become a better team.
Enjoy your new favorite chair
[email protected]
www.neochair.com
@NEOCHAIR
neochair_office
If there are any problems, do not hesitate to e-mail us. [e-mail]
DBS
Headrest models comes with below part

7.
Put the armrest on the bottom
of the seat and tighten with
three bolts on each side.
Instructions
1.
STEP 1 Bottom
STEP 2
Top
5.
Use the box for
an easier assembly.
Press the base leg until
you hear "CLICK."
Insert gas lift cylinder
into the center of the base.
6.
Line up the armrest and the back.
Loosely tighten with two bolts.
Repeat on the other side.
Fix the base leg with one hand and
insert five wheels into the base.
Insert the base leg vertically into the base.
TIPS!
2.
3.
Ouch! Be careful not to get
your hands caught in the gap.
WHEEL X5
MAKE SURE TO
REMOVE THE GAS LIFT CAP
GAS LIFT
CYLINDER X1
BASE LEG X1
4.
For proper alignment:
Slightly under-tighten the bolts.
BACK X1
ARMREST X2
Please use the allen key included
instead of an electric drill.
※NOTICE
For proper alignment:
Slightly under-tighten the bolts.
X6
A
X6
C
X4
A

Check
Tilt Tension
User Manual
Right hand Tension
Adjustment
FRONT
Once all of the armrests bolts are in place,
fully tighten every bolt.
Mount the seat onto the
gas lift cylinder
Match the front stickers and
secure the Control Mechanism to the seat.
8.
9.
10.
Tilt
Height
UP
Down
Lumbar
X4
B
X4
C
STEP 3
Top + Bottom
This step is only for a
model with headrest
HEAD REST X1
fully tighten
x 10
UP
Down