NETGEAR WG302v1 - ProSafe 802.11g Wireless Access... Quick guide

WG302v2, WAG302v2 –DHCP: Use and Configuration
The WG302v2/WAG302v2 can act as a DHCP server for wireless client. The
WG302v2/WAG302v2 provides the pre-configured TCP/IP configuration for wireless clients
connected to the access point.
The WG302v2/WAG302v2 DHCP server only assigns network information to clients that connect
to the access point through security profiles that are on the same VLAN as security profile 1.
VLAN 1 is the default VLAN for all security profiles.
Enabling the DHCP server on the WG302v2/WAG302v2 causes Network Address
Translation (NAT) to be enabled on the access point - The WG302v2/WAG302v2 in this case
acts similar to a NAT router for the wireless clients who receive their network information from the
access point. All network traffics from the wireless client designated to the wired network are
NAT-ed to the access point’s LAN IP address.
As a result, the DHCP network (wireless network) configured in the WG302v2/WAG302v2 DHCP
settings must be in a different subnet than the wired network.

NETGEAR
Internet Access RouterFirewall
LOCAL
PWR TEST 1 2
LNK
INTERNET
ACT 4
100
LNK/ACT
3
MODEL
FR314
Router
192.168.0.1
Wireless Clients 192.168.1.2-192.168.2.50
Wired device 192.168.0.x
192.168.0.228
WG302v2/WAG302v2
In the above example, the wired network where the router and the access point resided is
192.168.0.0/24. When enabling the DHCP server on the WG302v2/WAG302v2, the DHCP
network must be in a different subnet than 192.168.0.0/24. In our example, we use
192.168.1.0/24.
To enable DHCP server on the WG302v2/WAG302v2, go to Advanced->IP Settings in the access
point’s management interface. Select the radio button to enable DHCP server. Enter the starting
and ending IP Address of the DHCP pool, subnet mask, gateway IP address, primary and
secondary DNS server addresses, primary and secondary WINS server addresses and lease
time. Click Apply.

Wireless clients connect to the WG302v2/WAG302v2 will receive one of the addresses from the
DHCP pool. However, DNS Server address assigned to the wireless client will always be the
same address as the default gateway address. It was because the WG302v2/WAG302v2 uses
DNS proxying. The wireless client’s DNS requests are sendt to the access point then proxy to the
designated DNS Server specified in the DHCP setting.
This is specific for v2 of WG302 and WAG302. WG302v1 and WAG302v1 DHCP server works
differently. Refer to the reference manuals of WG302v1 and WAG302v1 on how to setup DHCP
server on those access points.