NeuraLabel 600e User manual
NeuraLabel 600e Printer
Installation Guide
1
2
•2 people to lift printer from the box.
•A sturdy table that can hold the printer. Recommended minimum
table size of 24” x 24” with 48” clearance for printing.
•Access to an electrical wall outlet for direct printer plug in.
•Access to a network wall outlet for direct network plug in. Network
cable is provided. (Or USB may be used.)
Unpack Printer Box and Accessory Box
Locate the following
3
You Will Need
600e Power Cable
NeuraLabel 600e CFA
(Continuous Feeder Attachment)
NeuraLabel 600e Printer
4
Network Cable
Printer Placement
For this step you will need a NeuraLabel 600e Printer.
Use two people to place the NeuraLabel 600e Printer on a sturdy table. Allow space for the
media to be fed into the printer either from the table or the floor. Allow space for the media to
exit the printer onto the table or the floor.
5
CFA Installation
For this step you will need a NeuraLabel 600e CFA.
The NeuraLabel 600e CFA hooks onto the mounting hardware of the NeuraLabel 600e printer.
The left hook on the NeuraLabel 600e CFA fits in between the alignment hooks on the mounting
hardware. Refer to the figure for detail.
6
Connect CFA to Printer
Figure 7
7
Caution! Ensure that the Printer power is OFF before plugging in your CFA.
Connect Printer to Power
Figure 9
You may now power on the NeuraLabel 600e Printer.
Caution! Do not unplug CFA while the printer is on. Doing so may damage your printer.
8
Next Steps
•Plug printer into network and obtain network address.
•Verify CFA has booted up and the LED is lit.
•Green is gap sensor mode.
•Blue is side mark sensor mode.
•Magenta is middle mark sensor mode.
•Not all CFAs support all modes.
•Download and install NeuraLabel 600e driver.
www.neuralabel.com/600e
•Load marked media with mark face down.
9
Technical Support
Contact NeuraLabel Printing Solutions
for further help.
•1-281-240-2525 X16
•support@neuralabel.com
10
Other manuals for 600e
2
Table of contents
Other NeuraLabel Printer manuals
