
NZR 1.5 A1 GB│IE│NI │ 7 ■
♦ Remove all packaging material.
Power supply
♦ Use a 1.5V battery 6to operate the appliance.
To insert the supplied battery 6proceed as follows:
1) Carefully pull the housing 7off the hand set 4
and place it to one side.
2) Insert the battery 6. Pay attention to the polarity
markings given in the battery compartment.
3) Push the housing 7back onto the hand set 4until it sits
firmly in place and the gap is fully closed. The anti-slip
dimples on the housing 7must be on the same side as
the anti-slip dimples on the hand set 4. The writing on
the housing 7must be on the same side as the operat-
ing button 5.
NOTE
► If the effectiveness of the cleaning starts to decrease, the
battery 6needs to be replaced.
Handling and use
This section provides important information about proper hand-
ling and operation of the appliance.
Fitting the cleaning attachment
1) Remove the appliance head 1by turning it slightly so
that the dot on the appliance head 1is aligned with the
symbol on the hand set 4. Then pull the appliance
head 1upwards and off.
2) Push the attachment fitting 3into the hole of one of the
cleaning attachments 2in the storage box 8. You will
feel a slight click.
3) Pull the hand set 4away from the storage box 8. The
cleaning attachment 2comes out of the storage box 8.
4) Check that the cleaning attachment 2is firmly attached
to the attachment fitting 3. If necessary, push the cleaning
attachment 2onto the attachment fitting 3with slightly
more force.
IB_290413_NZR1.5A1_DK.indb 7 19.05.17 11:53