Next 759388 User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings please contact Customer
Services Tel: [phone]
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
• Do not use abrasive cleaning products or those containing silicone.
• Do not rub or scrub the surface when cleaning.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Ensure the castors are locked when the product is in place.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found
to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions.
• Carefully check that you have all parts before beginning assembly.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of 2 persons is required to assemble this product.
• For general cleaning, periodically dust with a soft cloth.
PRODUCT INFORMATION
CARE INSTRUCTIONS
•A mattress measuring 90cm x 190cm with a maximum thickness of 17cm is intended for use with this child's bed.
• Made in China.
• Children are likely to play, bounce, jump and climb on beds, therefore the child's bed should not be placed too close
to other furniture or windows, and should be placed either tight to any wall or have a gap of 300mm between the wall
and the side of the bed side.
759388 SLEEPOVER TRUNDLE
Page 1 of 2

Note - Unfold legs prior to assembling the
underbed.
1. Attach 2 x Rails (2) to Bed frame (1) using 4 x Bolts
(A), 4 x Spring Washers (C) and 4 x Washer (B),
ti
g
hten usin
g
Allen Wrench
(
D
)
.
2. Attach 2 x Wheels (3) and 2 x Brake Wheels (4) to
the le
g
s
,
ti
g
hten usin
g
S
p
anner
(
E
)
.
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
STEP ONE
FITTINGS
PARTS
Page2of2