Next 864609 User manual

Tools Needed
Helpline
If you have any problems with this product or
require any replacement fittings please
contact Customer Services Tel: [phone]
8999
• Carefully check that you have all parts before beginning assembly.
• We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
PRODUCT INFORMATION
• Made from Pine with NC lacquer finish.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of 2 persons is required to assemble this product.
ASSEMBLY INSTRUCTIONS.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is
found to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
• Made in China.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking,
discolouration or warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent
scratching or damage.
• Do not rub or scrub the surface when cleaning.
CARE INSTRUCTIONS
• Natural features ensure that each piece is individual. Every effort is made to ensure colour continuity between
pieces, however this is a natural product, slight colour variations and natural grain markings may occur.
• We recommend that the extending dining table is left fully extended and uncovered for the first few months so
that the natural mellowing process occurs evenly across the table top.
• Do not put hot dishes directly on the surfaces of the item.
• Always use a non-silicone based furniture polish. Silicone in furniture polishes can break down the lacquer
finish.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if
necessary.
• For general cleaning, periodically dust with a soft cloth.
864609 XM HARTFORD BENCH SET
(TABLE)
Page 1 of 4

PARTS
FITTINGS
Page 2 of 4

1. Insert 4 x dowels (D) into 2 x rails 2.
2. Insert 4 x dowels (D) into 2 x rails 3.
1. Insert 2 x bolts (A) into legs 4 & 5 and
tighten by hand.
2. Attach legs 4 & 5 to rail 2 using 2 x half
moon washers (B) and 2 x nuts (C).
Tignten using wrench (F).
4. Repeat above steps to assemble the other
set of legs, using legs 4 & 5 and rail 2.
1. Insert 2 x bolts (A) into legs 4 & 5 and
tighten by hand.
2. Attach legs 4 & 5 to rail 3 using 2 x half
moon washers (B) and 2 x nuts (C).
Tignten using wrench (F).
3. Repeat above steps to assemble the other
set of legs unit to rail 3.
STEP ONE
STEP THREE
STEP TWO
Page 3 of 4

1. Attach assembled unit to table top 1 back.
2. Insert 18 x screws (E) into rails 2 (x2) & 3
(x2) and tighten with a screwdriver.
STEP FOUR
Next Retail Ltd, Desford Road, Enderby, Leicester, LE19 4AT
Page 4 of 4