Next Leamington 763477 User manual

Tools Needed
Helpline
If you have any problems with this product or
require any replacement fittings plase contact
Customer Services Tel: [phone]
• We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration
or warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• Do not use abrasive cleaning products or those containing silicone.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent
scratching or damage.
• Do not put hot dishes directly on the surfaces of the item.
• For general cleaning, periodically dust with a soft cloth.
• Do not rub or scrub the surface when cleaning.
• Always use a non-silicone based furniture polish. Silicone in furniture polishes can break down the lacquer finish.
• Use non-silicone beeswax to maintain the shine.
• Do not use furniture polish.
• Use a furniture oil periodically to maintain the finish and prevent the oil from drying out.
PRODUCT INFORMATION
• Made of steel with a Cream Brass powder coated finish .
• Made in China.
CARE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is
found to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• Carefully check that you have all parts before beginning assembly.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of persons persons is required to assemble this product.
Leamington Cream Brass
Headboard
763477
第 1 页，共 4 页

• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if
necessary.
PARTS
FITTINGS
STEP ONE
A.Boltsx2
M6X35mm
C.Allen key x 1
4mm
B.Metal Washer x 2
M6
(1) Headboard X 1
(3) Foot Slider X 2
( 2) Finials X 2
(4) Foam Pads X 2
1.Attach Foot Slider (3) to Headboard (1) )
by using Bolts (A), Metal Washer (B)and tightening
with
Allen key (C).Peel the rear tape from the Foam Pads
(4)
and stick them to the base of the Foot Slider (3).
第 2 页，共 4 页

Next Retail Ltd, Desford Road, Leicester, LE19 4AT
1.Attach finials (2) to Headboard (1) .
STEP TWO
第 3 页，共 4 页

第 4 页，共 4 页