Next LEAMINGTON NICKEL 988724 User manual

Tools Needed
Helpline
If you have any problems with this product or require
any replacement fittings please contact Customer
Services Tel: [phone]
• Made from steel with a nickel plated finish and poplar sprung wooden slats.
ASSEMBLY INSTRUCTIONS.
IMPORTANT - RETAIN FOR FUTURE REFERENCE - READ CAREFULLY.
Regrettably self assembly items cannot be returned once assembly is part or fully completed unless the item is found
to be faulty. Should you need to return the unassembled product, please repack in the original packaging.
IMPORTANT
• Carefully check that you have all parts before beginning assembly.
• We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions.
• Made in China.
CARE INSTRUCTIONS
• For general cleaning, periodically dust with a soft cloth.
• Do not rub or scrub the surface when cleaning.
• Keep fittings out of children's reach and keep children well away from the construction area.
• We recommend that the packaging is used to protect the surfaces during assembly.
• A minimum of two persons is required to assemble this product.
PRODUCT INFORMATION
• Do not put hot dishes directly on the surfaces of the item.
• Avoid keeping furniture in direct sunlight or close to any heat sources as this can cause cracking, discolouration or
warping.
• Never drag pieces of furniture across the floor as this will cause damage to the joints.
• All assembly fixings should always be tightened properly and periodically check all fixings and tighten if necessary.
• Do not use abrasive cleaning products or those containing silicone.
• Any spills should be removed immediately with a soft clean damp cloth and dried immediately.
• Ensure the product is protected with mats and coasters when items are placed on the surfaces, to prevent scratching
or damage.
LEAMINGTON NICKEL BED SINGLE 988724
page 1 of 4

FITTINGS
PARTS
Nickel
page 1 of 4

1. Attach 4 x foot sliders 7 to headboard 1 and
footboard 2 using 4 x bolts (B) and 4 x metal washers
(D), tighten with Allen key (E). Peel the rear tape from
4 x foam pads 10 and stick them to the base of the
foot sliders 9.
1. Attach side rails 3 (x2) to headboard 1 and
footboard 2 using 8 x bolts (A), 8 x plastic washers (C)
and 8 x metal washers (D). Tighten using Allen key
(E).
1. Attach cross bars 4 (x2) to the brackets on side
rails 3 (x2) using 4 x bolts (A) and 4 x metal washers
(D). Tighten with Allen key (E).
NOTE: Ensure the threaded insert holes in cross bars
4 (x2) are facing downwards.
STEP ONE
STEP TWO
STEP THREE
page 1 of 4

1. Insert a sprung wooden slats 5 through the first
hole in strap 9.
2. Attach single sided slat cap 6 onto one end of the
sprung wooden slat 5. Attach another single sided
slat cap 6 onto the other end.
3. Insert one end (with fitted cap) into the first hole in
side rail 3. By lifting up in the centre and pushing
down on the other end, insert into opposite hole in
the opposite side rail 3.
4. Repeat process for all remaining slats and caps
until all components have been used and firmly
pushed in place.
1. Attach 4 x nickel finials 8 to headboard 1 and
footboard 2 turning clockwise by hand to tighten.
STEP FIVE
Next Retail Ltd, Desford Road, Leicester, LE19 4AT
STEP FOUR
page 1 of 4