NexxTech 4908422 User manual

Door Alarm and
Entry Chime
OWNER'S MANUAL
4908422
Please read before using this equipment.

Door Alarm and Entry Chime
FEATURES
Your Nexxtech Door Alarm and Entry
Chime is a convenient and easy-to-use
security device. It chimes when someone
enters a room or sounds an alarm when
someone opens a door or window. Itís
great for keeping kids out of hazardous
areas! Its features include:
Simple Installation -no wiring is re-
quired and all mounting hardware is in-
cluded.
Electronic Chimes -announc e a visi-
torís entry.
Loud Alarm -warns intruders and
alerts you.
SecurityCode -restricts access to
those who know the four-digit security
code and lets you choose from 10,000
possible code combinations.
Delay-gives you 8 seconds to open
the door and enter the security code be-
fore the alarm sounds.
Panic - sounds the alarm without open-
ing the door.
Note: You can use the alarm on almost
any door, sash and casement window,
cabinet, or closet. The alarm might not
work on steel doors because the sensors
are magnetic.
PREPARATION
Installing the Battery
Your alarm requires one 9-volt battery for
power. For the best performance and
longest life, we recommend an alkaline
battery.
Caution: Use only a fresh battery of the
required size and recommended type.
1. Set the slide switch to Off.
2. Use a Phillips screwdriver to remove
the two screws from the bottom of
the alarm.
illustration
illustration

2
3. Put your fingers into the holes on the
back cover and lift to remove the
cover.
4. Snap the battery connector over the
battery’s terminals.
Note: If the alarm sounds, enter the
preset factory security code, 1234, to
silence it (see “Setting the Security
Code” on Page 4).
5. Replace the cover, then reinsert and
tighten the screws.
Replace the battery when any of the fol-
lowing occurs:
• the chimes’ or alarm’s sound
becomes weak
• the red indicator does not light
• the alarm does not work at all when
the door opens
• the alarm sounds a steady tone, and
you cannot stop it by entering the
security code
• the alarm stops sounding before you
enter the code or before 90 seconds
pass
If the alarm does not respond after you
replace the battery, remove the battery
and reinstall it. Each time you remove the
battery, the security code resets to 1234.
Cautions:
• Always remove an old or weak bat-
tery. Batteries can leak chemicals
that can destroy electronic parts.
• Dispose of the old battery promptly
and properly. Do not burn or bury
them.
Installing the Alarm
For proper alignment, you must mount
the alarm and magnet so the magnet
rests with its arrow pointing toward one of
the alarm’s markings. Choose a location
that lets you install the magnet on a door
or window and the alarm immediately
next to it on the frame, or vice versa. The
distance between the alarm and magnet
must be no more than 5/16 inch (as shown
here).
illustration
illustration
illustration

3
Use the supplied screws or the supplied
adhesive tape and follow these steps to
mount the alarm and magnet.
1. If you are mounting the alarm using
the supplied screws, remove the two
screws on the bottom of the alarm
and remove the back cover.
2. Use three of the five supplied long
screws or the two larger pieces of the
supplied adhesive tape to mount the
back cover.
Note: If you need to drill starter holes
for the screws, use the back cover as
a template.
3. Slide the alarm onto the mounted
back cover.
4. Replace the two screws on the bot-
tom of the alarm.
5. Use the two remaining long screws
or the smaller pieces of the supplied
adhesive tape to mount the magnet
so its arrow points toward one of the
markings on either side of the alarm.
To check the installation, set the alarm’s
slide switch to Chime and open the door.
You should hear the electronic chimes. If
you do not, readjust the position of the
magnet.
illustration
illustration
illustration
illustration
illustration

4
Setting the Security Code
You can set your own four-digit security
code.
Notes:
• Your alarm’s security code is preset
to 1234 at the factory. We recom-
mend you use a different security
code.
• You must enter all four numbers
within 15 seconds, or the red indica-
tor turns off and the alarm exits the
procedure and resets to the previous
security code.
• If you remove the battery, the secu-
rity code resets to 1234.
Follow these steps to set your own secu-
rity code.
1. Press CODE. The red indicator lights.
2. Enter the current security code. The
red indicator flashes.
3. Enter the desired four-digit code. The
red indicator lights steadily.
4. Press CODE within 5 seconds to
store the code. The red indicator
turns off.
Note: If you do not press CODE
within 5 seconds, the red indicator
turns off and the alarm exits the pro-
cedure and resets to the previous
security code. Start over at Step 1.
Checking the Security Code
Follow these steps to check your security
code.
1. Set the slide switch to Dela
y
and
open the door.
2. Enter the security code within 8 sec-
onds. The red indicator lights briefly.
If the indicator does not light or the
alarm sounds, you entered the wrong
security code. Remove and reinstall
the battery to reset the code to 1234,
then change the code again.
OPERATION
You can set the alarm to announce visi-
tors, alert you to intruders, or sound a
panic alarm, or you can turn it off.
illustration
illustration

5
Announcing Visitors
To have the electronic chimes sound
when someone opens the door, simply
set the slide switch to Chime.
Alarm Mode
When you do not expect visitors, set the
slide switch to Instant. If someone opens
the door, a piercing alarm sounds for 90
seconds or until you enter the security
code.
Note: After 90 seconds, the alarm resets
to sound again the next time the door
opens.
When leaving your house, remember to
first set the slide switch to Off. Then,
open the door, set the slide switch to
Delay, and leave the house, closing
the door behind you.
When you return, you must enter the se-
curity code within 8 seconds or the alarm
will sound.
Panic Alarm
To immediately sound the alarm without
opening the door, press PANIC. The
alarm sounds for 90 seconds or until you
enter the security code.
Note: After 90 seconds, the alarm resets.
Turning the Alarm Off
To turn off the alarm and the electronic
chimes, simply set the slide switch to Off.
Notes:
• You can still use PANIC with the slide
switch set to Off.
• You cannot set the slide switch to Off
to silence the alarm. You must enter
the security code, wait 90 seconds
for the alarm to stop sounding, or
remove the battery.
illustration
illustration
illustration
illustration

5A8N Printed in Hong Kong
CARE AND MAINTENANCE
To enjoy your Door Alarm and Entry
Chime for a long time:
• Keep the alarm dry. If it gets wet,
wipe it dry immediately.
• Use and store the alarm only in nor-
mal temperature environments.
• Handle the alarm gently and careful-
ly. Don’t drop it.
• Keep the alarm away from dust and
dirt.
• Wipe the alarm with a damp cloth oc-
casionally to keep it looking new.
Modifying or tampering with the alarm’s
internal components can cause a mal-
function and invalidate its warranty. If
your alarm is not performing as it should,
take it to you local electronics store for
assistance.


5A8N Printed in Hong Kong
LIMITED WARRANTY
Who is Providing This Warranty?
• Orbyx Electronics, LLC (“Orbyx), as the distributor of this
Nexxtech product (your “Product”).
What Does This Warranty Cover?
• This warranty covers defects in materials or workmanship in your
Product under normal use and conditions.
What is the Period of Coverage?
• This warranty covers your Product for 12 months from the original
purchase date.
Who Is Covered?
• This warranty covers the original consumer purchaser. Coverage
terminates if you sell or otherwise transfer your Product.
What Will We Do To Correct Problems?
• We will repair your Product or replace your Product with a new or
reconditioned equivalent product, at our option.
How Do You Get Service?
• Call Orbyx TOLL FREE at 1-866-363-3059 for instructions for
obtaining warranty service from Orbyx’s authorized service
providers.
• Or, return your Product directly to the retail store from which you
purchased the Product.
• When you obtain service for your Product, you must provide a
purchase receipt (or other proof of the original purchase date)
and a description of the defect(s).
What Does This Warranty Not Cover?
• This warranty DOES NOT COVER:
• damage due to misuse, abuse, alteration, unauthorized repair, or
accident (such as improper electrical current);
• damage due to “acts of God” (such as lightning) or other
contingencies beyond our control;
• cosmetic damage;
• externally generated static, signal reception or antenna problems
not caused by your Product; or
• batteries.
• This warranty also DOES NOT COVER, and in no case will we
be liable for, any incidental damages (such as transportation
costs to and from an authorized service provider, or loss of time)
or consequential damages (such as costs of repairing or
replacing other property which is damaged, including tapes,
discs, speakers not included with your Product or other
accessories, or external electrical systems) resulting from the use
of your Product. Some states do not allow the exclusion or
limitation of incidental or consequential damages, so the above
limitation or exclusion may not apply to you.
• Defacing the serial number, or using your Product for commercial
or institutional purposes, voids this warranty.
Are There Other Warranties?
• There are no express warranties other than those expressed
herein. Neither the sales personnel nor any other person is
authorized to make any other warranties or to extend the duration
of any warranties.
• ANY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED
WARRANTY OF MERCHANTABILITY (AN UNWRITTEN
WARRANTY THAT A PRODUCT IS FIT FOR ORDINARY USE),
ARE LIMITED TO 90 DAYS. Some states do not allow limitations
on how long an implied warranty lasts, so the above limitation
may not apply to you.
How Does State Law Apply?
• This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
ORBYX ELECTRONICS WARRANTY
ORBYX Electronics warrants that this product will be free
from defects in materials and workmanship for a period of
one (1) year from the date of purchase. Within this period,
simply take the product and your proof of purchase to any
ORBYX Electronics store or dealer and the product will be
repaired without charge for parts and labour. ORBYX
Electronics reserves the right to charge for transportation.
Any product which has been subject to misuse or accidental
damage is excluded from this warranty.
This warranty is only applicable to a product purchased
through ORBYX Electronics' company owned stores and
dealers and to a product that is presented for repair in a
country where ORBYX Electronics offers the product for
sale. While this warranty does not confer any legal rights
other than those set out above, you may have additional
statutory rights which will vary under the laws of the various
countries, states, province and other governmental entities
in which ORBYX Electronics operates. This warranty is
subject to all statutory rights you may have in the country of
purchase.
Distributed exclusively in the U.S. by
Orbyx Electronics, LLC
501 South Cheryl Lane,
Walnut, CA 91789
Imported in Canada for/Importé au Canada pour
Orbyx Electronics,
Concord, Canada, L4K 4M3
Manufactured in China
For parts, service, and general inquiries please call 1-866-363-3059
Pour pièces, service et demandes générales, s’il vous plaît, appelez
1-866-363-3059
GARANTIE ORBYX ELECTRONICS
ORBYX Electronics garantit ce produit contre tout vice de
matière ou de fabrication pour une période d'un (1) ans à
compter de la date d'achat. Au cours de cette période, vous
n'avez qu'a retourner le produit, accompagné d'une preuve
d'achat, à tout magasin ou detaillant ORBYX Electronics où il
sera réparé sans frais pour les pièces et la main-d'oeuvre.
ORBYX Electronics se réserve le droit d'imputer des frais de
transport. La garantie ne s'applique pas aux produits
endommagés suite à un mauvais usage ou à un accident.
La garantie s'applique qu'a un produit acheté dans un magasin
de la compagnie ORBYX Electronics ou chez un détaillant
ORBYX Electronics et à un produit qui est vendu dans le pays où
l'on fait la demande de réparation au titre de la garantie. Bien
que cette garantie n'accorde aucun droit particulier autre que
ceux susmentionnés, il se peut que vous puissez jouir d'autres
droits qui varient selon le pays, l'état, la province ou l'entité
gouvernementale où ORBYX Electronics exerce ses affaires.
Cette garantie se conforme à tous les droits légaux que vous
pourriez avoir dans le pays d'achat.
LIMITED WARRANTY
GARANTIE LIMITEÉ
Limited Warranty/Garantie Limiteé
U.S.A & Canada
© 2004 ORBYX Electronics. All Rights Reserved.
4908422
Table of contents
Other NexxTech Intercom System manuals
Popular Intercom System manuals by other brands

Talkaphone
Talkaphone ETP-120 Series Installation & operation manual

X-Vision
X-Vision XAM300H instruction manual

Unitech
Unitech Tashi MT200 Quick reference guide

Spacetronik
Spacetronik SPD-M771 user manual

Hollyland
Hollyland SOLIDCOM C1 quick start guide

Tema Telecomunicazioni
Tema Telecomunicazioni AA-539 Technical manual and installation guide