NightSearcher HT2IN1LED User manual

NightSearcher products have been carefully tested and inspected before shipment
and are guaranteed to be free from defective materials and workmanship for a
period of 12 months from the date of purchase, provided that the enclosed
instructions have been followed.
Should you experience problems with your NightSearcher product, please return the
item, complete with any chargers, to your place or purchase or contact
NightSearcher Ltd direct.
Address and contact details;
NightSearcher Limited
Unit 4 Applied House
Fitzherbert Spur
Farlington
PORTSMOUTH
Hampshire
PO6 1TT
UK
T: [phone] | E: [email protected]
If upon inspection it is found that the fault occurring is due to defective materials or
workmanship, repairs will be carried out free of charge. This guarantee does not
apply to normal wear and tear, nor does it cover any damage caused by misuse,
careless / unsafe handling, alterations, accidents, or repairs attempted or made by
any personnel without prior approval from NightSearcher Ltd.
Batteries are consumable items and are not covered by this guarantee. Your
guarantee is not effective unless you can produce a dated receipt of purchase.
Please note that this guarantee does not affect your statutory rights.
If at any time, you need to dispose of this product or parts of this product: please note
that waste electrical products, bulbs and batteries should not be disposed of with
ordinary household waste. Recycle where facilities exist. Check with your local
authority for recycling advice.Alternatively, NightSearcher is happy to take receipt of
this product at end-of-life and will recycle it on your behalf.
HT2IN1LED
DUAL FUNCTION PROFESSIONAL LED TORCH
USER MANUAL
NIGHTSEARCHER LIMITED
Unit 4 Applied House, Fitzherbert Spur, Farlington
Portsmouth, Hampshire, PO6 1TT, UK
T; [phone] | F; [phone]
E: [e-mail] | www. nightsearcher.co.uk
Safe disposal of waste electrical products, batteries and bulbs
WARRANTY

Please read this User Manual before using your NightSearcher product, as it
contains important safety information and operating instructions. Following
this advice will help ensure that your product operates to its maximum
potential.
Light modes
High
Low
Flashing *
SOS-Flashing *
Light output
(lumens)
85
10
Light source
Cree White LED
Run time (hours)
1
20
4
23
Battery
1x 1.5V AA Alkaline
Product size (mm)
Ø22 x 95
Product weight
(kg)
0.062
Boxed size (mm)
W135 x H180
Boxed weight (kg)
0.072
Product Code
NS2IN1LED
*flashing mode specifications cannot be measured by ANSI FL1 standard.
Flashing mode runtime is based on measurement of battery capacity
change only.
Supplied with : headlight bracket, headstrap and battery.
Light Emitting Diodes (LED) can last over 50,000hrs and seldom need to be
replaced.
1. Unscrew the end cap and remove it from the unit
2. Remove the old battery and replace with one new 1.5V AA size alkaline
battery, inserting positive end of battery first
3. Replace the end cap
Attach Angle Light To Headlight Holder
1. Hold the angle light with clip facing the headlight holder.
2. Align the angle light tracks to the fingers of the holder
3. Glide the angle light into the headlight holder.
The multimode switch is located on one end of the torch and offers rapid
one-handed mode change, even wearing gloves.
After 3 seconds in any mode, pressing switch again turns torch off.
CREE LED –Up to 85 lumens
4 Lighting modes –High, Low & SOS-Flashing & Flashing.
Special designed reflector for projecting search light up to 70m.
Multimode switch for easy selection of modes
Dual purpose : headtorch and flashlight
90° angled light
Integrated clip on housing
Robust aluminium body
Wipe the lens clean with a soft cloth and a non-corrosive detergent.
If putting lamp into storage for a long period, remove the battery.
Do NOT look directly into the LED light for more than a few seconds
Do NOT allow children to use the LED light unless under the supervision of
an adult
Remove the battery if not using the LED light for over 30 days or before
storage
Do not try to repair the unit yourself. Please contact NightSearcher or an
authorised distributor
Do not expose the light to fire/high temperatures or extreme wet/cold
conditions
SAFETY PRECAUTIONS
MAINTENANCE
FEATURES
ON / OFF & MODE OPERATION
BATTERY REPLACEMENT
LED ASSEMBLY REPLACEMENT
TECHNICAL SPECIFICATION