Nilfisk-Advance Focus II Rider Installation and user guide

Page: 1
Focus II Rider How To
Prepare for Use
1
Check batteries, turn on
switch to check battery
indicator (battery fully
charged).
2
Select proper brush,
inspect then Install
brush (Disc System)
under scrub deck. Align
brush gimbal (push until
it locks).
3
Install pad (Boost
System) by first
removing the side skirt.
Line up pad with the
fixed pad drive then
press into place.
4
Install rear squeegee.
Do not over tighten.
Connect the recovery
hose to the squeegee
inlet.
5
Make sure ball float
system and debris
catch cage is clean.
6
Fill with water (Below
130°F); add detergent
(follow dilution ration).
Machine Operation
1
Familiarize yourself
with the control panel
and all of its functions
for scrubbing and
transporting.
2
Press the Solution
Control and Scrub
switch. Adjust the
Solution Control as
needed.
3
Begin scrubbing
process.

Page: 2
Focus II Rider How To
Store the Machine
1
Empty and rinse
recovery tank, catch
cage and ball float.
2
Remove, rinse and
inspect rear squeegee.
3
Remove, rinse and
inspect brushes or
pads.
4
Empty and rinse
solution tank with clean
water. Wipe down the
exterior of the machine
as necessary.
5
Drain water into an
open drain.
6
Wipe exterior of the
machine.
7
Charge machine for
next shift.
Daily Maintenance:
•Charge Batteries
•Check/clean
tanks & hoses
•Check/Clean/rot
ate brushes/pads
•Check/Clean
squeegee
•Check/Clean
shut-off float
•Empty/clean
debris catch
cage
Weekly:
•Check battery
cell water level
•Inspect scrub
housing skirts
•Inspect/Clean
Solution filter
•Purge Detergent
System
Periodically:
•Lubricate
machine - Monthly
•Check carbon
brushes - Yearly