Nilfisk-Advance SC450 Parts list manual

Nilfisk A/S
Kornmarksvej 1
DK-2605 Brøndby
Denmark
Tel.: [phone]
Fax: [phone]
mail.com@nilfisk.com
www.nilfisk.com
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to carry out this this
procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE RED SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
Use & maintenance
- SC450
17. Charge the batteries: Connect the
battery charger cable from the
electrical main
16. Clean the machine using a damp
cloth and where needed use a
neutral cleaning product
18. Park the machine with the recovery
tank cover open
15. Clean the filter by: Remove the
transparent cover and the gasket
14. Check and clean the squeegee
blades
10. At the end of the work. Empty
the recovery tank with the hose. Then
empty the solution tank with the
trasparent hose
11. Wash with clean water the recovery
tank and the vacuum grid
12. Remove the brush/pad and clean
them
13. Take the squeegee off and remove
debris.
5. Place the brush or the pad-holder
under the deck. Use the appropriate
brush to clean the floor.
9. Press the handle switch to engage
the brush and run the machine
6. Adjust (if needed) the brush deck
to have the correct machine
directionality
8. Switch on the brush and vac motors
to activate the machine
7. Press the eco solution flow control
valve
2. Fill the tank with a clean water. The
clean water temperature must not
exceed 40 °C.
1b. Disconnect the battery charger
cable from the electrical main.
3. If the squeegee is not connected to
the machine: install and fasten it with
the handwheels, then connect to the
suction hose
1a. Switch off charger by unplug
charger cable from red battery plug.
Reconnect the red battery plug to
the machine.
.
4. If the squeegee is in upper position,
lower it with the lever
ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual
All manuals and user guides at all-guides.com
all-guides.com

Nilfisk A/S
Kornmarksvej 1
DK-2605 Brøndby
Denmark
Tel.: [phone]
Fax: [phone]
mail.com@nilfisk.com
www.nilfisk.com
The machine
doesn’t work
as it should?
The suction
doesn’t work
as it should?
The machine
doesn’t clean
as it should?
The brush
don’t work as they
should?
Troubleshooting
- SC450
ATTENTION! Do not use the machine before you have read and understood the Instructions for User Manual
1Check if the power cable is correctly
connected.
2Check if the battery is charged.
1Check if the brush are correctly in-
stalled and not worn out.
2Check if there isn’t any brush motor
overload i.e. 3 battery Ledsflash si-
multaneously.
3Check if there are external materials
avoiding brush rotating.
1Check if the suction hose is
correctly installed and cleaned.
2Open the recovery tank and check
if the vacuum grid and gasket are
cleaned.
3Check if squeegee blades are
damaged or dirty.
4Close the recovery tank cover
properly and/or verify the gasket
wear.
1Check if you have the right water
settings.
2Check if the solution filter is
cleaned.
All manuals and user guides at all-guides.com