Nokia NPL-4 Series Installation instructions

Nokia Customer Care
NPL-4/5/RM-104 Series Transceivers
Issue 2 05/05 Copyright © 2005 Nokia Corporation. All rights reserved
Disassembly Instructions

NPL-4/5/RM-104
Disassembly Instructions Nokia Customer Care
Page 2 Copyright © 2005 Nokia Copyright. All rights reserved Issue 2 05/05
Table of Contents
Page No
Disassembling Instructions ................................................................................................................... 3
Exchange of System Connector........................................................................................................... 5
Reassembly procedure .........................................................................................................................6

Nokia Customer Care NPL-4/5/
Issue 2 05/05 Copyright © 2005 Nokia Copyright. All rights reserved Page 3
Disassembling Instructions
Note! Do not open the unit if you don’t have a torque driver, which is
capable of 32 Ncm, but send the product to the appropriate service sup-
plier with higher service level.
Attention!
It is not allowed to open the unit more than once, oth-
erwise the unit is not splash proofed any more and has
to be sent to the appropriate
service supplier with higher service level. Always use
new screws for assembly.
Press the grip markings on both sides of the B-Shell and
remove B-Shell.
Remove Keymat. Remove the A-Shell.
Unscrew the six screws, using the order shown and a
screwdriver TORX PLUS® size 6.For assembly, the reverse
order and a torque of 32Ncm have to be used.
Take away the UI Module Assy with Engine Module.

NPL-4/5/RM-104
Disassembly Instructions Nokia Customer Care
Page 4 Copyright © 2005 Nokia Copyright. All rights reserved Issue 2 05/05
Separate the UI-Module from Engine Module carefully,
because of the board-to board-connector.
Push out the LCD by using a clean cloth.
Protect LCD with a film. Remove the Speaker with Kirk Boot. Note the guiding
when assembling.
Use tweezers to remove Speaker from Kirk Boot. Use a slotted screwdriver as a lever to open the Camera
Shield.
Camera Module is attached with four snaps into its
guidance. Place SRT-10 as shown in the picture and unlock
the snaps on both sides. Note releasing order.
Use tweezers to take away the Camera module.

Nokia Customer Care NPL-4/5/
Issue 2 05/05 Copyright © 2005 Nokia Copyright. All rights reserved Page 5
Exchange of System Connector
(PICTURE EXAMPLES TAKEN FROM Nokia 5100, NPM-6)
The System Connector is attached with double-sided
adhesive gasket to C-Cover. Also note the gasket on
C-Cover.
Press SRT-6 between C-Cover and System Connector and
remove Battery Cover.
Press again SRT-6 between C-Cover and System Connector
and remove System Connector.
Remove System Connector.
To remove the remaining adhesive gasket use SRT-6 only.
Do not use sharp-edged tools for this procedure.
Remove protection foil from System Connector.

NPL-4/5/RM-104
Disassembly Instructions Nokia Customer Care
Page 6 Copyright © 2005 Nokia Copyright. All rights reserved Issue 2 05/05
Reassembly procedure
Reassembly takes place in reversed order compared to disassembly.
Place System Connector to its guidance exactly. Now press connector to C-Cover firmly, while taking care
not to slip C-Cover on your table.