Nokia X1-01 User manual

Nokia X1–01 User Guide
Issue 1.
1

Contents
Safety 3
Get started 4
Your dual SIM device 4
Insert the SIM card and battery 4
Insert or remove a memory card 6
Charge the battery 6
Switch on or off 7
Your phone 8
Keys and parts 8
Set which SIM card to use 9
Make a call 10
Text input 10
Send a message 11
Save a name and phone number 12
Save numbers in five separate
phonebooks 12
Listen to music 13
FM Radio 14
Flashlight 15
Support 15
Product and safety information 15
Index 20
2Contents

Safety
Read these simple guidelines. Not following them may be dangerous or illegal. Read
the complete user guide for further information.
SWITCH OFF IN RESTRICTED AREAS
Switch the device off when mobile phone use is not allowed or when it may
cause interference or danger, for example, in aircraft, near medical
equipment, fuel, chemicals, or blasting areas.
ROAD SAFETY COMES FIRST
Obey all local laws. Always keep your hands free to operate the vehicle while
driving. Your first consideration while driving should be road safety.
INTERFERENCE
All wireless devices may be susceptible to interference, which could affect
performance.
QUALIFIED SERVICE
Only qualified personnel may install or repair this product.
BATTERIES AND OTHER ACCESSORIES
Use only batteries, chargers and other accessories approved by Nokia for use
with this device. Do not connect incompatible products.
KEEP YOUR DEVICE DRY
Your device is not water-resistant. Keep it dry.
PROTECT YOUR HEARING
Listen to a headset at a moderate level, and do not hold the device near your
ear when the loudspeaker is in use.
Safety 3

Get started
Your dual SIM device
You can insert two SIM cards.
Some benefits of a dual SIM device
•You can make savings when you use services from different service providers.
•Use one phone number for personal calls and another for work, but carry only one
device.
•Avoid network coverage variation between service providers.
Both SIM cards can be connected to the network at the same time, but while one SIM
card is active, for example, making a call, sending or receiving a message, or transferring
data, the other is unavailable.
Insert the SIM card and battery
Note: Switch the device off and disconnect the charger and any other device
before removing any covers. Avoid touching electronic components while changing any
covers. Always store and use the device with any covers attached.
Important: Do not use a mini-UICC SIM card, also known as a micro-SIM card, a
micro-SIM card with an adapter, or a SIM card that has a mini-UICC cutout (see figure)
in this device. A micro SIM card is smaller than the standard SIM card. This device does
not support the use of micro-SIM cards and use of incompatible SIM cards may damage
the card or the device, and may corrupt data stored on the card.
Important: To prevent damage to the SIM card, always remove the battery before
you insert or remove the card.
The SIM card and its contacts can be easily damaged by scratches or bending, so be
careful when handling, inserting, or removing the card.
You can use your phone with one or two SIM cards inserted.
1 Place your finger in the recess at the bottom of the phone, and carefully lift and
remove the back cover (1).
2 If the battery is inserted, lift the battery out (2).
4Getstarted

3 If inserting only one SIM card, open the SIM 1 card holder (3). Make sure the contact
area is facing down, and insert the SIM card (4). Close the holder.
4 To insert a second SIM card, open the SIM 2 card holder (5). Make sure the contact
area is facing down, and insert the SIM card (6). Close the holder.
5 Line up the contacts of the battery and the battery compartment, and insert the
battery (7). To replace the back cover, direct the top locking catches toward their
slots (8), and press down until the cover locks into place (9).
This phone is intended for use with the BL-5J battery.
Get started 5

Insert or remove a memory card
Use only compatible memory cards approved by Nokia for use with this device.
Incompatible cards may damage the card and the device and corrupt data stored on the
card.
Memory cards may be available separately.
Your device supports microSD cards with a capacity of up to 16 GB.
Insert a memory card
1 Open the cover of the memory card slot.
2 Insert the memory card. Push the card in, until it locks into place. Make sure the
contact area is facing up.
3 Close the slot cover.
You can remove or replace the memory card without switching the device off.
Remove the memory card
Important: Do not remove the memory card when an application is using it.
Doing so may damage the memory card and the device, and corrupt data stored on the
card.
1 Open the cover of the memory card slot.
2 Push the card in gently, until it is released, and pull the card out.
3 Close the slot cover.
Charge the battery
Your battery has been partially charged at the factory, but you may need to recharge it
before you can switch on your device for the first time.
6Getstarted

If the device indicates a low charge, do the following:
1 Connect the charger to a wall outlet.
2 Connect the charger to the device.
3 When the device indicates a full charge, disconnect the charger from the device,
then from the wall outlet.
Tip: To save energy, unplug the charger when the battery is fully charged.
You do not need to charge the battery for a specific length of time, and you can use the
device while it is charging.
If the battery is completely discharged, it may take several minutes before the charging
indicator appears on the display or before any calls can be made.
If the battery has not been used for a long time, to begin charging, you may need to
connect the charger, then disconnect and reconnect it.
It may take longer than expected before the device is fully charged, due to the large
capacity of the BL-5J battery.
Switch on or off
Press and hold the end key.
Use the phone only in its normal operating position.
Avoid touching the antenna area unnecessarily while the antenna is transmitting or
receiving. Contact with antennas affects the communication quality and may cause a
higher power level during operation and may reduce the battery life.
Get started 7

Your phone
Keys and parts
1End/Power key
2Earpiece
3Display
4Selection keys
5Navi™ key (scroll key)
6Call key
7Keypad
8Microphone
8 Your phone

9Wrist strap hole
10 Music keys
11 Charger connector
12 Flashlight
13 Headset connector/Nokia AV Connector (3.5 mm)
14 Memory card slot
15 Loudspeaker
Set which SIM card to use
You can set which SIM card to use for outgoing calls or messages. If you name your SIM
cards, you can see at a glance which is, for example, for work and which is for personal
use.
Select Menu > Settings > Dual SIM settings.
1 Select from the following:
Default SIM for calls — Set which SIM card to use for outgoing calls.
Default SIM for msgs — Set which SIM card to use for outgoing messages.
Standby mode — Set which SIM card to be active for all incoming and outgoing
communications.
Your phone 9

2 Select SIM1 or SIM2. To be prompted to select a SIM card before, for example,
making a call or sending a text message, select Ask every time.
Rename a SIM card
Select SIM name.
Tip: To quickly change the default SIM card, on the home screen, press and hold *.
Make a call
1 Enter the phone number, including the country code and area code, if necessary.
2 Press the call key.
3 If prompted, select the SIM card to use.
4 To end the call, press the end key.
Tip: If you have set the default SIM card used for making calls, you can still select which
SIM card to use. After entering the phone number, instead of pressing the call key, select
Options > Call.
When you receive a call, the SIM card in use is indicated.
Use the loudspeaker or earpiece
During a call, select Loudsp. or Hands..
Change the volume
During a call, scroll left or right.
Text input
Write text
To enter text, you can use traditional or predictive text input. Not all languages are
supported by predictive text input.
Use traditional text input
Press a key repeatedly until the desired letter is displayed.
Activate predictive text input
Select Options > Dictionary and the desired language.
Deactivate predictive text input
Select Options > Dictionary > Dictionary off.
10 Your phone