Norbord Shaped OPEN BASE Cabinets User manual

Cross Head Screwdriver
Drill
Level
3mm
Drill Bit
5mm
Drill Bit
1 x Narrow Back Panel
1 x Side
1 x Top
1 x Base
1 x Shelf
1
2
3
4
5
1
3
4
Panels Hardware
ASSEMBLY GUIDE
Minimum Tools required
Hammer
2
Shaped
OPEN BASE
Cabinets
NARROW BACK
2 x D
5
8 x C15mm
Legs
Please use scissors to open the
bag of fittings and then empty
the contents into a bowl, so
that they do not get lost!
Before you Start …
WARNING: Installation should be performed by a competent person only. This product could
be dangerous if incorrectly installed. All assembly fittings except legs and shelf pegs have
been pre-inserted. If any are missing or there is a problem with the panels, please call the
Manufacturers’ Helpline on 01769 575500, and their team will get things sorted.
Video assembly guides can be viewed at www.mycabinetguide.co.uk
Cleaning – Use mild soap and water only. Do not use abrasive cleaners.
2 x S1 x U
2 x T1 x V

Fit panels & to panel (Narrow Back Panel)
3 4 1
Fit panel to panel
51
1
Fit panel to panels , &
2 3 4 5
4
Tighten the cams as you go
3
Now affix your cabinet legs
5
4
3
1
2
5
4
3
1
1
2
3
CSS1324 09/13

To fit legs, turn unit upside down
Fitting of Legs
Care should be taken when fitting legs and fitting to wall as Unit will be heavy
4
Lay plinth panel in front of cabinet legs. Position plinth clip plate opposite front
cabinet legs. Secure with 2 x screws .
Slide into . Stand plinth up.
C
U
V
T
U
Fitting Worktop
U
5
6
To fit plinths
7
All legs are pre-set at 150mm height.
Rotate to adjust up and down, to level the unit.
Drill a 5mm hole through both side panels.
Join together using joining bolts .
Levelling, & Joining
D
Drill through top panel.
Use 2 x to fix work top to unit
K
Cabinet
Underside
Position as shown.
Ensure screwhole is not
over panel join.
4
Tap in the central
plastic lug
Secure with screw
x 3 positions.
Then push leg into
leg boss .
S
S
Rotate to adjust
height
C
C
TT
S
S
Drill pilot holes
3mm x 3 positions

CSS1324 09/13
Notes: