Novis BetterLiving BL1430 Manual instruction

Prior to use please read all instructions
Suitable for most ‘A’ framed wheeled
walkers; consult the manufacturer’s
manual to confirm suitability
Do not use with oxygen cylinders
larger than 125 mm in diameter
(maximum ‘C’ size)
Suitable for all BetterLiving Wheeled
Walker models excluding the Tri-
Wheel and Shopper
To attach the carrier
Remove the wire shopping basket (if applicable)
and slightly fold the wheeled walker.
Vinyl bags do not need to be removed.
Position the oxygen bottle carrier with the open end facing
your preferred side.
Hook the carrier onto the crossbars
underneath the seat; 2 hooks over rear
bar followed by 2 hooks over front bar.
Unfold the wheeled walker and check
oxygen bottle carrier is secure before
closing the seat.
Note, hooks may not sit flush
against the crossbar; this
is acceptable as long as
carrier is secure and
firmly attached to the
wheeled walker.
If intending to use the seat function;
we recommend that
the wire basket is not
reinserted while the
oxygen bottle carrier is
attached (to ensure full closure of the seat).
To install the oxygen bottle
Unscrew the locking pin at the top of the carrier until the
rubber stopper is flush with the edge (do not remove
completely).
Designed to fit under the seat of
most ‘A’ frame wheeled walkers,
the oxygen bottle carrier suits an
oxygen cylinder up to 125 mm in
diameter (‘C’ size). Carrier is angled
slightly for optimal oxygen supply
and to prevent the oxygen bottle
from sliding out.
Slide the oxygen cylinder into the open end of thecarrier,valve
endfirst (sovalve ispositionedagainst the closed end of the
carrier). Tighten the lockingpinuntil therubberstoppersits
firmlyagainst the oxygen bottle to secure.
Check the bottle is secure and fully inserted before use.
cross section
of cross bar
Oxygen Bottle Carrier
SET UP AND OPERATION

Care & cleaning
To clean the carrier, wipe with a clean damp cloth and dry
thoroughly.
Avoid using abrasive cleaning agents or utensils (such as a wire
brush) as these may damage the anodised/painted finish, or
plastic and rubber components.
Warranty
Novis Healthcare Pty Ltd warrants this product for a period
of 12 months. Please refer to our Warranty Statement for
full details. Please contact your authorised dealer or the
manufacturer for a list of available spare parts.
Specifications
CODE BL1430
LENGTH 370 mm
HEIGHT 420 mm
WEIGHT 1.2 kg
CONFORMS TO
ARTG 229461
AS EN 12182-2002
Technical Aids for Disabled Persons
WARRANTY One year
Made in China
pressure care and patient handling specialists
novis.com.au /1300 738 885 FEBRUARY
2017 ©