Numatic TWINTEC CABLE TT4055 Installation and operation manual

2.
4.
1.
3.
5.
Clean out the debris lter basket
located under the seperator hood.
Empty the recovery tank and rinse
thoroughly with clean water.
Clean suction pod lter in the
seperator hood behind the black ap.
Ensure the seperator is clean and un-
damaged. Replace seal if necessary.
IMPORTANT: Remove to clean under-
side of squegee from dirt and debris.
NTT4055DMVNo1
REPORT ALL DAMAGES AND TECHNICAL ISSUES TO THE SUPERVISOR
AFTER EVERY USE, ENSURE
THAT YOU COMPLETE THE
FOLLOWING 6 STEPS
NUMATIC TWINTEC CABLE
TT4055
DAILY MAINTENANCE CHART
6.
Store machine with seperator lifted
from the tank to avoid condensation.

AFTER EVERY WEEK, ENSURE
THAT YOU COMPLETE THE
FOLLOWING 4 STEPS
1.
3.
2.
4.
Check all all hoses for damage, holes and
obstructions. Clean and replace as necessary.
Thoroughly clean top seperator hood and
seal.
Remove squegee and check for wear and
damage. Clean thoroughly. Remove brushes/pad drives and
check for wear and damage.
NTT4055WMVNo1
REPORT ALL DAMAGES AND TECHNICAL ISSUES TO THE SUPERVISOR
NUMATIC TWINTEC CABLE
TT4055
WEEKLY MAINTENANCE CHART
2
3
4
1