NUTRICHEF PSLWPMP50 User manual

by
www.PyleUSA.com
PSLWPMP50 - PSLWPMP100

CATALOG
1. Clean Before First Use
2. Brief Introduction
3. User Instructions
4. Clean and Store
Don’t forget to register with us online to receive your free 1 year
warranty!
http://www.pyleaudio.com/ProductRegistration.aspx

We suggest that you run clean water through the Aerator before
rst use. The product is designed to seal on a standard wine
bottle mouth opening and will only push water through the
tube and spout if used in a sealed state.
CLEAN BEFORE FIRST USE
SPECIFICATIONS
SIZE
WEIGHT
POWER SOURCE
WATERPROOF
Φ60*162.5 MM
 TUBE AND SPOUT NOT INCLUDED 
218 G  BATTERIES NOT INCLUDED 
6 X AAA BATTERY
IP44

BRIEF INTRODUCTION
Mixes Wine & Air to Provide a
Purer Wine Taste & Experience!

BRIEF INTRODUCTION
PART A.
(Top Cover)
PART B.
(Electronic
Body Assembly)
lndicator
Light
Top Cover
Switch
Dispense
Switch
Tube Cap
Battery
Compartment
Spout
Inlet
Air Injector Hole

Top Cover
Switch
Remove the Top Cover from
the Electronic Body Assembly
by pressing the Top Cover
Switch and turn the cover to
the right (counterclockwise)
and pull the cover up and o
the Electronic Body Assembly
to expose the battery
compartment
Insert 6 x AAA 1.5V batteries.
Follow the polarity instruction
in the battery compartment.
With the "-" (negative) end of
the battery against the spring.

• Open the bottle of wine and insert the
tube of Wind Aerator into the bottle and
gently press the Aerator down over the
bottle mouth
• Place your glass under the spout, and
press the Dispense Switch on the top of
Electronic Body Assembly to dispense
instantly an erated wine directly into your
glass. Indicator Light over the spout go
red when working.
• Release the dispensing button before
your remove the glass from under the
spout.
Connect the Plastic Tube to the spout
under the Electronic Body Assembly by
pressing the tube end with the tube cap

CAUTIONS
If the activation button
is not fully depressed,
the dispensing speed
of the wine and the
aeration amount will
be reduced.
Because of the indented base shape of most wine
bottles, using a fully dispensed bottle will leave
1-2 ounce of wine in the bottle. As the liquid level
in the bottle reaches the bottom of the plastic
tube, a frothy mix of air and wine will be pushed
up the tube. To prevent this last bit of wine drawn
through the Wine Aerator from spraying wine
bubbles from the spout, please put the mouth of
your glass up close to the spout when you reach
the bottom of your bottle. The Plastic Tube is
suitable for most of wine bottle, only few special
shape of the bottle will not match.

Clean
Channel 1
Clean
Channel 2
CLEAN AND STORE
CLEAN AND STORE
1. After use immediately clean and dry.
2. Two clean Channel, make sure Dispense Switch on Top Cover
is locked before cleaning.
3. Do not use detergents to clean the Aerator channel. Add a little
lemon juice or vinegar to the rinsing water in the bottle if you
want to improve the cleaning eect of ushing with water.
4. Remove the battery if you will not use it for a long time.
5. Wipe clean and dry then store in the original product packaging.
6. This product is not a toy and contains small parts that is not
suitable for children under 5 years of age.

by