NUTRICHEF PKBRTP60 User manual

www.NutriChefKitchen.com
HomebrewMiniKegBeerDispenser
PKBRTP60-PKBRTP110
2L 4L 5L 10L Mini Keg with Spear Tap CO2
Regulator System.
UNIT OPERATION INSTRUCTION
1. Mini keg Growler 2L 4L 5L 10L.
2. Cap Spear Body
3. Gas In Connection Tube
4. Pressure Relieving Valve 30PSI.
5. Cross-bar
6. Regulator Base
7. 30 PSI Pressure Gauge
8. CO2 Regulator Knob
9. CO2 Regulator Aluminium Body
10. Black Plastic Tap Handle.
11. Chrome Plated Faucet Body
12. 16g Threaded CO2 Cartridge/Capsule
PART ONE: SPEAR ACCEMBLY
1. Please clean mini keg,
cap, spear body, faucet
and beer hose with warm
water and mild soap
before use.
2. Fill your mini keg at your
favourite craft brewery,
or with your own
homebrew.
3. Cut beer hose according
to keg height and insert into Spear, make sure
hose can touch bottom of keg without overlong
or over short.
Remark: If hose is too short, beer would not be
tapped completely. But if hose is too long, it may
crimp inside the keg, also cause incomplete tapping.
4. Fit tube on to spear, and screw spear into mini keg.
5. Check whether the regulator knob is in OFF
position. If not, please follow arrow mark instruc
tion to turn the regulator knob counter clockwise
to the OFF position.
1
3
2
45
10
11
12
8
7
9
6
6. Turn in a new 16g CO2 Capsule with thread type
of 3/8-24UNF, turn clockwise rmly into the
regulator base.
NOTE: DON’T stop turning if you hear a slight gas
leak swish, nish turning it in all the way it seal
properly.
PART TWO: TAPPING
1. Connect the regulator with capsule to the spear.
2. Install Faucet into Spear Body, make sure the
connection is proper and tight.

www.NutriChefKitchen.com
Remark: Improper combination would cause
leakage of beer.
3. Pull on pressure relieving ring for a couple of
seconds. If the keg was shaken in transit or
warmed, it may contain excessive pressure which
must be relieved before tapping. A hissing noise is
expected.
4. Slowly turn the regulator knob in clockwise
direction to 5 PSI, and stop for 2 seconds ad turn
o regulator. Wait for 2 mins, then pull on the
pressure relieving ring for a couple of seconds.
This is for adjusting pressure of keg beer.
5. Put a glass or pitcher under the faucet spout, with
the faucet knob pulled forward (ON), slowly turn
the regulator knob on in clockwise direction, until
beer starts to ow out.
In case there is CO2 leakage, please observe the
position of leakage and continue with the tightening
process, but never screw out if gas remains.
PART FOUR: WARNING
1. Keep away from children under 18.
2. Never point cylinder towards someone’s face.
3. Do not heat over140°F as rupture may occur!
4. Discontinue using of this equipment if unsolvable
leakage or visible damage is found.
5. Capsule end become punctured when turned
into regulator base. Unscrewing before it’s empty
can result in loss of high pressure gas. Please
remember, never unscrew the CO2 capsule before
gas used up, liquid CO2 spray onto unprotected
skin may cause freezing burns.
6. Exterior of capsule may become frozen when in
use, this is normal. But don’t touch with bare
hands, your ngers could stick to the frozen
surface and cause frostbite.
7. Please ship via land or sea shipment, never bring
CO2 capsule when you travel by air.
Don’t continue adding pressure, suggest tapping
5-8 PSI (Max pressure 30 PSI), so please stop
turning the regulator knob when the pressure is
enough to tap beer out with perfect foam. Too
much pressure would cause over foam. When the
beer stopped or ow slower, try turning the
regulator knob on slowly, to get bigger pressure.
6. When you nish tapping, please turn regulator
knob to OFF position.
7. If there is no beer owing out, then the CO2
capsule needs to be replaced, unless no beer is
remained (Normally, 16g capsule can tap 4-5 liters
of beer).
Caution: Removing a punctured capsule from
regulator should be done slowly. Swish is expected
if pressure remains.
8. Turn the regulator knob o and install a new
capsule into the regulator by following above
steps.
TROUBLE SHOOTING GUIDE
1. Faucet Leakage
Solution: Screw out and remove the faucet, then
install again, make sure the faucet can match the
connection of spear tightly.
2. Too much Foam
Solution: Decrease the pressure properly.
3. Leakage of CO2
CO2 capsule should be installed properly and
tightly.
Questions? Issues?
We are here to help!
Phone: [phone]
Email: [email protected]
This product can expose you to a chemical or group of checmicals, which
may include ”Chromium” which is known in the state of California to cause
cancer, birth defects, or other reproductive harm. For more info, go to
https://www.p65warnings.ca.gov/.