NUTRICHEF PKIS11 User manual

Electric Ice Shaver
User Manual
PKIS11
NutrichefKitchen.com

2
IMPORTANT SAFETY INSTRUCTIONS
To prevent personal injuryor property damage, read and follow all instructions
andwarnings.
When using electrical appliances, basic safety precautions should always be
followedincluding:
• Read all instructions.
• To protect against fire, electric shock, and injury to persons do not immerse
cord, plugs, or other electric parts in water or other liquids.
• Close supervision is necessary when this appliance is used by or near children.
• Always unplug from outlet when not in use and before cleaning. Allow to cool
before putting on or taking off parts and before cleaning.
• Do not operate any appliance with a damaged cord or plug, after the appliance
malfunctions, or has been damaged in any manner. For service information see
warranty page.
• The use of accessory attachments not recommended by Focus Electrics may
cause fire, electric shock, or injury.
• Do not use this appliance outdoors.
• Do not let cord hang over the edge of the table or counter, or touch hot surfaces.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• Plug cord into wall outlet. To disconnect, remove plug from wall outlet.
• Do not use appliance for other than intended use.
• Do not attempt to repair this appliance yourself.
• A short power-supply cord is provided to reduce risks resulting from becoming
entangled in or tripping over a longer cord.
• Longer extension cords are available, but care must be exercised in their use.
While use of an extension cord is not recommended, if you must use one,
ensure that the marked electrical rating of the extension cord is equal to or
greater than that of the appliance. If the plug is of the grounded type, the
extension cord must be a grounding-type 3-wire cord. To avoid pulling, tripping
or entanglement, position the extension cord so that it does not hang over the
edge of the counter, table or other area where it can be pulled on by children or
tripped over.
• This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit into a polarized outlet
only one way. If the plug does not fit fully into the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician. Do not attempt to modify the plug
in any way.
• Do not use an outlet or extension cord if the plug fits loosely or if the outlet or
extension cord feels hot.
• Avoid contact with moving parts.

3
• Blade is sharp. Use extreme caution during assembly, while operating,
disassemblyand cleaning.
• Do not use if blade is broken, cracked or loose.
• Do not leave appliance unattended while it is operating.
• Do not run this appliance continuously for more than 5 minutes as overheating
may occur. Allow motor to cool down before repeat usage.
• Do not run machine without ice in the auger as damage to appliance may occur.
• Never place fingers or utensils into the feed or discharge areas to reduce the
risk of severe injury to persons or damage to the shaver.
• Always check auger and exterior bowl for presence of foreign objects before
using.
• For household use only.
SAVE THESE INSTRUCTIONS
Lid
Gear Ring
Securing Nut
Auger
Exterior Bowl
Motor
Base
BEFORE USING FOR THE FIRST TIME
Please check all packaging material carefullybefore discarding. Many
accessoryparts are contained within the packaging material.
Assemble the motor to the base; place narrow end of motor into the opening in the
base. Press firmly until motor is securely seated in the base. If desired for storage,
the motor can be removed from the base.
Hand-wash the cup holder, exterior bowl, and auger in warm, soapy water. Rinse
and dry thoroughly. Do not wash any parts in a dishwasher.
CAUTION: The exterior bowl contains a sharp shaving blade, handle with
care.
NEVER IMMERSE THE MOTOR IN WATER OR ANY OTHER LIQUID.

4
USING YOUR ELECTRIC ICE SHAVER
1. If using paper cone cups, push cup holder into opening on front of ice shaver
housing. If using regular cups, do not attach cup holder.
2. Slide the gear ring over the auger and snap in place. You will hear a click when
it is fullyengaged.
3. Place the auger with gear ring inside the exterior bowl. Lock the auger in place
with the securing nut by turning nut clockwise.
4. Line up the two outside tabs of the exterior bowl assembly with the matching
grooves on the Ice Shaver Housing. Push gently in place to secure.
CAUTION: The exterior bowl contains a sharp shaving blade, handle with care.
5. Place paper cone cups in cup holder. If using regular cups, place cup under the
shaving blade on the drip tray.
6. Add ice cubes to auger and plug the machine in.
7. Place the lid on top of the exterior bowl, aligning the tabs. Turn the lid counter-
clockwise until the lid tab engages the interlock switch. The motor will start and
the ice will begin shaving.
8. To stop shaving ice, turn the lid clockwise to disengage the motor switch.
CAUTION: Do not run ice shaver continuously for longer than 5 minutes as
overheating may occur. Allowmotor to cool down before repeat usage.
• A small amount of smoke and/or odor may occur upon use due to the
release of manufacturing oils –this is normal.
• Some minor expansion/contraction sounds may occur during use –this is
normal.
CLEANING YOUR ELECTRIC ICE SHAVER
1. Always unplug appliance before cleaning.
2. Hand wash parts in warm, soapy water. Rinse and dry thoroughly.
3. CAUTION: Be extremely careful of shaving blade in exterior bowl as blade is
very sharp.
Note: Do not wash parts in a dishwasher.
4. Clean exterior of the appliance with a damp, soft cloth and wipe dry.
Note: Do not immerse motor housing in water or other liquid.
NEVER ATTEMPT TO SHARPEN SHAVING BLADE AS INJURY MAY OCCUR.
This appliance has no user serviceable parts.
HELPFULHINTS
• Be sure you have an adequate supply of ice cubes.
• If your motor is laboring or if you get poor shaving results, soften your ice cubes.
This can be done by letting your ice sit at room temperature for a few minutes,
or running briefly under cool tap water.
• DO NOT overfill the auger; the cover should sit flush without forcing.
• Cube shaped ice performs better than the half-moon shaped ice from ice
makers or round cubes from store-bought bagged ice.

5
COOL &EASY TREATS
Super Snow Cones - Shave ice directly into snow cone cups. Mound tops with
additional shaved ice if desired. Dispense your favorite Jelly Belly™premium
flavored syrup directly on top of the shaved ice. Combine different syrups to create
your own unique flavors. Because the shaved ice is so fine, it absorbs the flavored
syrup instead of letting it run to the bottom. This gives you a truly intense flavor
sensation, all the way through! Tip: Use flavored ice cubes for unique snow cone
tastes. Freeze fruit juice, soda, flavored yogurt, or flavored milk into cubes. Shave
into cups. If desired, use Jelly Belly™premium flavored syrups for added flavor.
Slushes - Place shaved ice into serving cups or glasses. Add just enough Jelly
Belly™premium flavored syrup to totally absorb into the shaved ice. Garnish with
sliced or diced fruit.
Soda - Use your favorite variety such as cola, root beer, and fruit flavors. Add a
twist of lemon or lime for an added “burst” of flavor.
Fruit Juices - Natural flavorings that are both tasty and good for you. Try apple,
grape, orange, grapefruit, and cranberry or any combination for a special treat.
Lemonade and Punch-Flavored Drinks - Cool and refreshing flavors are great for
anyoccasion.
Rainbow Slush - A colorful and fun treat. Place a layer of shaved ice in the bottom
of a tall, parfait style glass; add syrup flavor. Add a middle layer of ice; add a
different syrup flavor. Add a top layer of ice and another syrup flavor. Garnish with
fruit or paper umbrellas. A great party treat!