ObboMed MT-5180 User manual

1
Dual Channels -
TENS Electronic Pulse Massager Unit
Model No.: MT-5180
Please carefully read through this manual before first use, and store it in safe place.
If you pass the product to another person, hand over this manual along with it!
Your healthy living center
www.obbomed.com
0197
EXPLANATION SYMBOLS
DANGER: Warning of risk of serious injury or health hazards
WARNING: Warning of risk of injury or health hazards
CAUTION: Safety informaon about possible damage to appliance/ accessories
NOTE: Important informaon
INTENDED USE OF PRODUCT
PRODUCT FEATURES
SCOPE OF DELIVERY (ACCESSORIES)
- This product is not designed for hospital/ medical use.
- This product is designed to relieve muscle pain.
- This product is designed for adults and should never be used on infants or young children. Consult your physician
or other health care professionals before use on older children.
- Use device only for its intended use described in the manual.
- Dual channels can run separate intensity for different demands.
- Ulizes Transcutaneous Electrical Nerve Smulaon (TENS) therapy
- Relieves fague and joint pain while improving metabolism
- 9 massage modes and 9 levels of intensity for customized relief
- 4 electrode pads aach to any part of the body
- Timer funcon set up from 1 minute to 30 minutes
- Large LCD screen: 50 x 25mm
- Main unit
- Electrode pads (2 pairs)
- Connecng wires
- Storage Case
- User’s manual
- Baery: Two AAA baeries included
All below informaon serves to protect health of user and the health of other person. Also protects the product from any
damage while using. Please read this secon carefully before using the unit.
- Do not operate the product with wet hands.
- Do not use in or around water.
- Do not place or store this product where it might fall into a tub, sink, or toilet.
- Do not use this product in a damp or humid environment or if the product itself is damp.
- The device might not meet its performance specificaons or cause safety hazard if stored or used outside
the specified temperature and humidity ranges in specificaons.
SAFETY & INSTALLATION INSTRUCTION

2
- In the unlikely event of product malfuncon, turn off power and stop using immediately. Please contact the local
dealer for repair. Any tampering voids warranty.
- Use the product only for its intended use as described in this manual.
- Do not use it when driving or using any machine or device.
- Do not put substances (e.g. medical or cosmec creams or loons) between the Electrode pads and skin.
- Do not use it at the heart, private parts or skin disease parts.
- Do not use aachments not provided with the product, or use the electrode pads other than supplied by the
manufacturer, it may bring biocompable hazard and might result in measurement error.
- Do not make any sharp knot in the connecng wires or electrodes.
- Do not use it for other purposes except treatment.
- Do not use the device if you are connected to, or in the vicinity of, high-frequency surgical or industrial equipment.
This may cause burn injuries to the skin under the electrodes, as well as problems with the smulator.
- Observe with cauon when using the device in the immediate vicinity of cellular phones that are switched on.
- Do not use the device in the direct vicinity of short-wave or microwave equipment, this may affect the output
power of the smulator.
- Simultaneous connecon of a paent to a h.f. surgical equipment may result in burns at the site of the smulator
electrodes and possible damage to the smulator.
- Applicaon of electrodes near the thorax may increase the risk of cardiac fibrillaon.
- Do not use with other electrical appliances.
- Do not share the electrode pads with other infecve person to avoid cross-infecon.
- Do not use this product while under the effects of alcohol, sleeping pills or sedaves.
- Turn off this product if you feel drowsy and before you fall asleep.
- Avoid dropping this product, as it is not shock resistant.
- Please keep this product out of reach of children or babies.
- Remove the baeries if the device will not be used for a long me to avoid damage of baery leakage.
- Keep the the main unit and baeries away from heat, direct sunlight, and moisture.
- Please do not use if you are/have:
• Pregnant
• Menstruang
• Sedated
• A fever
• Recovering from surgery
• Open wounds on your body
• Skin infecons or erupons
- Please do not use:
• Immediately before or aer meals
• With other electrical appliances
- User with implanted electronic equipment, such as pacemakers and intracardiac defibrillators must not use the
device without doctor’s advice. Pregnant women should not use the device during the first trimester, and should
always consult a doctor, midwife or physiotherapist prior to use.
- Please stop using it immediately if you experience any pain or discomfort while using this product, and consult
with doctors.
- This product s designed for adults and should never be used on infants or young children. Consult your physician
or other healthcare professionals before using on older children.
- If you have any concerns regarding to your health, consult your doctor before using this unit.
HEALTH PRECAUTIONS
OVERVIEW
Main Unit Display
On/ Off Display CH1+ CH2+ Mode +
CH1- CH2- Mode -
CH1
intensity
CH2
intensity
Electrode Pads
Connecng Wires
Selecng progam
Selecng mer
Minutes

3
PREPARATION
Baery Cover
Installing/ Replacing The Baeries
1. Slide the baery cover at the back of the unit.
2. Insert two “AAA” baeries as indicated in the baery compartment and then slide the baery cover back in place.
If the smulaon is too weak, please turn off the monitor and replace all baeries.
1. Plug in the electrode pads to the main unit. Both channels can be used simultaneously or
separately. Sck the pads to the desired parts.
2. Press the ‘ON/OFF’ buon, the device will be turned on, the LCD lights all display for
1 second, then the device goes into standby mode and wait for sengs.
3. Select the program of therapy. When the ‘ ’ sign shows on the LCD, press the ‘Mode +’
or ‘Mode -’ to select the desired program. Programs can be selected from 1 to 9.
4. Set the me of therapy. Press the ‘Mode’ and when the ‘ ’ sign shows on the LCD, press the
‘Mode+’ or ‘Mode -’ buons to adjust the desired treatment me. The mer can be adjusted
from 1 minute to 30 minutes, the default me is 15 minutes.
USING THE UNIT
5. To switch between the “PROG” and “TIME”, press the ‘Mode’ buon.
6. Set the intensity with CH1+/ CH1- and/ or CH2+/ CH2-, and the treatment will start. Different people need different
intensity, so increase the intensity from 0 to 9 slowly and carefully, stop increasing when reaching the desired intensity.
7. During the treatment, the ‘minute’ sign on LCD ( ) flashes unl the treatment ends. The unit will shut off
automacally.
8. If you want to end the treatment any me during the process, press the ‘ON/OFF’ ( ) buon.
9. When unplugging the electrode pads, hold the plugs. Pulling the wires may result damage.
10. Please use clear water to rinse the pads gently or use wet cloth (do not use facial ssue) to gently wipe the electrode
pads. Do not use brush or fingernail to clean the pads.

4
Problem Cause Soluon
No smulaon felt
The smnlaon is weak.
Power suddenly cuts
off during the
treatment process.
Low baery?
Are the baeries correctly loaded?
Is the wire properly connected?
Are the electrode pads firmly aached
to the skin?
Are the electrode pads overlapped?
Are the electrode pads dusty?
Is intensity too weak?
Are the electrode pads posioned properly?
Have the electrode pads come off the skin?
Are the wires disconnected?
Low baery?
Turn off the power and connect the
wire.
Please replace the baeries with new ones.
Turn off the power and aach the
electrode pads firmly to the skin.
Increase the intensity slowly and
see if it increases.
Change the posion of the electrode pad.
Please clean the electrode pads with wet
cloth.
Separate the electrode pads and aach
them to the skin again.
Aach the electrode pads firmly to the skin.
Properly connect the wires and the pins.
Check the polarity of baeries
Replace the baeries.
The skin becomes
red.
Is the treatment me too long?
Are the electrode pads too dry?
Shorten it to 10~15 minutes each me.
Please gently wipe them up with wet cloth
and then try again.
Are the electrode pads dusty?
Are the surface of the electrode pads
scratched?
Allergy problem? Please stop using and consult with your
dermatology doctor.
Please clean the electrode pads with wet
cloth.
Please replace them with new electrode
pads.
Are the electrode pads firmly aached to
the skin?
Aach the electrode pads firmly to the skin.
TROUBLESHOOTING
MAINTENANCE & STORAGE
Maintenance
To protect your unit from damage, please observe the following:
• Do not expose the unit to direct sunlight, and protect it from dust and moisture.
• Do not subject the unit to strong shocks or vibraons, such as dropping the unit on the floor.
• Do not use volale liquids to clean the main unit. Clean the unit with a so, dry cloth.
• Do not disassemble or aempt to repair the unit.
• In order to ensure the sckiness of the electrode pads, they should be cleaned carefully with a wet cloth.
• Aer each use, aach the electrode pads back onto the plasc film.
• Electrode pads is consumpve, please contact the local retailer to buy a new pair of electrode pads when the pads is
no longer adhesive.
Storage
• Do not fold electode pads.
• Store the unit and the electrode pads in its storage case in a clean dry place.
• Keep the product out of reach and sight of children.
• Remove the baeries from the unit if not used for long me.
Disposal
Disposal of packing and product aer end of lifeme.
Deliver all packing materials at a collecon point or in the appropriate bins for recycling.

5
Product Name: Dual Channels - TENS Electronic Pulse Massager Unit
Item Number: MT-5180
Power source: DC 1.5V x 2, 2 AAA baeries (included)
Main unit size: Approx. 128 mm x 56 mm x 16 mm
Weight: Approx. 67.4 g (exclude baeries)
Treatment program: 9 programs
Pulse frequency: 2 - 80 Hz
Output voltage: 30V ± 20%
Operang condion: Temperature: 5°C ∼40°C
Humidity: ≦80%
Storage condion: Temperature: -20°C∼55°C
Humidity: ≦95%
Pressure: 80 KPa - 105 KPa
Classificaon: Type BF applied part, IPX0, No AP or APG
Technical specificaons are subject to change without noce.
TECHNICAL DATA
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operaon is subject to the following two condions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operaon.
WARRANTY
The statutory warranty period applies. If the product is defecve, please contact the manufacturer's service centre (see
service e-mail at the end of this manual) or your retailer. For repair and warranty processing, please include the following
documents when you send in the product:
• A copy of the receipt with purchasing date.
• A reason for the claim or descripon of the fault.
No guarantee is provided when the product is not installed/ operated according to this manual, used for other purposes
or careless use of the product.
EXPLANATION OF SYMBOLS ON UNIT
Symbol for “Read the user’s manual”
Symbol for “Type BF applied parts”
(the cuff is type BF applied part)
Symbol for “Waste Electrical and
Electronic Equipment”
Symbol for “Manufacturer”
Symbol for “Date of Manufacture”
Symbol for “Keep dry”
Symbol for “Compiles With
MDD93/42/EEC Requirements”
Symbol for “Serial Number”
SN
0197

6
DISTRIBUTION & SERVICE
Manufacturer: Picard Healthcare Technology (Dongguan) Co. Ltd.
Address: No. 149, Chunfung Rd, Longbelin, Tangxia, Dongguan,
Guangdong Prov., China
European Representative: ObboMed Group B.V.
Address: Morseweg 11, 8503 Ah Joure, The Netherlands
Tel: [phone] 0197
Distribuon by ObboMed Group:
Webshop: www.obbomed.com
Europe:
Morseweg 11, 8503 Ah Joure
The Netherlands
Mail: [email protected]
United States:
1210 E Lexington Ave,
Pomona, CA 91766, U.S.A.
Mail: [email protected]
Australia:
39/3 Kelso Crescent Moorebank,
NSW 2170, Australia
Mail: [email protected]
ObboMed® is registered Trademark of ObboMed Group.