OFM 5100 Service manual

x8 x4x2
x1 x1
x1 x1
kg
3~15kg
A
Bkg
≤2kg
A+B=3~15kg
+
+
b
a
c
b
A B C
D
590mm
890mm
150-500mm
566mm
325mm
890mm
INSTALLATION GUIDE
Item No.: 5100
Technical Data
Pleasedonotexceedthe
maximumbearingweight
WAR NING
Accessory Package List
No. No. No.
No.
Spare par t Spare par t Spare par t
Spare par t
TOOLS
Assembly Step 1
Assembly Step 2
Remove all contents from the packaging
and place onto sturdy table.
CAUTION
Please place the product properly
according to size of it, or it may
harm or cause damage.
Buckle decorative cover to
the connecting arm.
Connect and fix the junction plate and
keyboard tray by 8 screws and use the
cross screwdriver to fasten afterwards.
Hang the junction plate on the knob
assembled and then tighten the knob
Tighten
Do not fasten too hard, otherwise the
screws may lose its efficacy.Just make
the head of screws flush with the
counterbore.
x1
E
No. Spare part

WARNING
!
Hands Pinching
Do not plac e your hand near the strut.
Strut's a ngle will change during t he desktop
lifts and i t may hurt you.
Based on the actual usage, hold the
both sides of table outer edges then
press the right handle to adjust the
workstation to a proper height.
WARNING
Please do not put hands near the
supporting bars, as they change
during adjusting and may hurt you.
Assembly Step 3
Assembly Step 4
Pleaseputthedevicesonto
thetopoftheworkstation.
CAUTION
Please make sure all installed
equipments are on the table, and do
not hang over table edge as this may
cause harm or damage.
This surfac e is with glue,
helping to fix the cable
managemen t on the table
Cable
Nylon ties
CAUTION
Adhesive buckle helps to make the cables
tidy and clean. Please leave enough
length of cable for height adjustment
function, otherwise it may cause
unexpected lost.
Please first adjust it to the highest,
then remove equipment to avoid
harm or damage.
Please move it by two persons, or
parts may collide and cause damage.
Please make sure all installed equipments
are on the table, and not sticking out of
the edge, or it may harm or cause damage.
Please leave enough length of cable for
height adjustment function, otherwise it
may cause unexpected lost.
Attention
Attention
Warning
Warning
Manufacturer: OFM Inc.
161 Tradition Trail
Holly Springs NC, 27540
800-520-7471
[e-mail]
www.ofminc.com
Please do not put hands near the supporting bars, as
they change during adjusting and may hurt you.
Warning
2
1Use the cable management to
guide and bundle the cables