OFM 5100C User manual

≤2kg
A+B=3~15kg
A:3~15kg
B:
+
b
a
c
b
x8 x4x2 x1
x1 x1
x1 x1
A B C
D E
＞950mm
588mm
mm005-051
579mm
566mm
325mm
870mm
1050mm
＞
610mm
INSTALLATION GUIDE
Item No.: 5100C
Accessory Package List
A
B
Technical Data
Please do not exceed the
maximum bearing weight
WARNING
No. No. No.
No.
Spare part Spare part Spare part
Spare part No. Spare part
TOOLS
Assembly Step 1
Remove all contents from the packaging
and place onto sturdy table.
CAUTION
Please place the product properly
according to size of it, or it may
harm or cause damage.
Assembly Step 2
Buckle decorative cover to
the connecting arm.
Connect and fix the junction plate and
keyboard tray by 8 screws and use the
cross screwdriver to fasten afterwards.
Do not fasten too hard, otherwise the
screws may lose its efficacy.Just make
the head of screws flush with the
counterbore.
Hang the junction plate on the knob
assembled and then tighten the knob
Tighten

WARNING
!
Hands Pinching
Do not place your hand near the strut.
Strut's angle will change during the desktop
lifts and it may hurt you.
2
1
Assembly Step 3
Based on the actual usage, hold the
both sides of table outer edges then
press the right handle to adjust the
workstation to a proper height.
WARNING
Please do not put hands near the
supporting bars, as they change
during adjusting and may hurt you.
Assembly Step 4 Please put the devices onto
the top of the workstation.
CAUTION
Please make sure all installed
equipments are on the table, and do
not hang over table edge as this may
cause harm or damage.
Assembly Step 5
Use the cable management to
guide and bund e the cables
This surface is with glue,
helping to fix the cable
management on the table
Nylon ties
Cable
CAUTION
Adhesive buckle helps to make the cables
tidy and clean. Please leave enough
length of cable for height adjustment
function, otherwise it may cause
unexpected lost.
Please do not put hands near the supporting bars, as
they change during adjusting and may hurt you.
Warning
Please make sure all installed equipments
are on the table, and not sticking out of
the edge, or it may harm or cause damage.
Attention
Please leave enough length of cable for
height adjustment function, otherwise it
may cause unexpected lost.
Attention
Please first adjust it to the highest,
then remove equipment to avoid
harm or damage.
Warning
Please move it by two persons, or
parts may collide and cause damage.
Warning
Manufacturer: OFM Inc.
161 Tradition Trail
Holly Springs NC, 27540
800-520-7471
[email protected]
www.ofminc.com