SF40A Printer Service Manual
Ohaus Corporation www.ohaus.com 1-4 SF40A Printer Service Manual
1.9 Replace DC Power Socket, Power Switch
1Open Unit, (see section 1.4).
2Disconnect affected cables.
3Pinch retaining clips and lift
switch A out.
1.10 Replace Keypad Overlay
Note: Once removed, the keypad cannot
be reused.
1Open Unit, (see section 1.4).
2Use a knife to prize up a corner of
the keypad and slowly pull it off.
3 Remove any residual adhesive (use
acetone if need be).
4On the new keypad, remove cover
film of adhesive surface.
5Insert ribbon cable in top housing
and line up the keypad with the edge
of the bottom rim of the depression in
the top housing. Now lay keypad in
the depression and press down.