OHCO R.6 User manual

R.6 Massage Chair!
Assembly Instructions
1. Remove the base of the chair from box 1
of 2 and place in the desired location.
2. Install the channel covers into the base of
the chair.
Please refer to the accessory and hardware list located on page 18 of the owner’s manual for
proper part names & reference images
3. Plug the female end of the power cord
into the back base of the chair, then plug
the male end of the power cord into a surge
protector.
4. Turn on the main power switch. Note, the
chair will automatically incline. Once the
chair has fully inclined, turn offthe main
power switch again.

R.6 Massage Chair!
Assembly Instructions
5. Remove the footrest from box 2 of 2.
Then, using the provided T-wrench,
remove the two 4mm cap head screws
located in the hinges at the front of the
base of the chair.
6. Place the footrest near the front of the chair,
then connect the one electrical connector and
the one airline from the footrest to the base of
the chair. Ensure that the electrical connector’s
tab faces upward and is fully snapped in, and
that the airline is pushed on as far as it will go.
7. Flip up the hinge flaps located on the
front base of the chair, then carefully lift
the footrest so it sits within the brackets.
8. Flip the hinge flaps back down and,
using the provided T-wrench, reinstall the
two 4mm cap head screws that were
removed in step 5. Note if hinges do not
fully close, wiggle the footrest until the
hinges are fully closed.

R.6 Massage Chair!
Assembly Instructions
9. Remove the right arm from box 2 of
2. Then, align the arm’s connection
points (upper hook, and the two bolt
holes on the base/bracket of the arm)
so its securely sitting on the body of
the chair.
10. Using the provided T-wrench, firmly secure the the
arm to the chair by carefully installing the two 4mm cap
head screws at the arm bracket connection located near
the seat of the chair.
11. Connect the one electrical connector
and the one airline from the arm to the base
of the chair. Ensure that the electrical
connector’s tab faces toward the back of
the chair and is fully snapped in, and that
the airline is pushed on as far as it will go.
12. Repeat steps 9-11 to install the left arm.

13. Install the remote control by connecting the female end, located on the end of the remote
control’s cord, to the male end located on the left side of the seat on the base of the chair.
Firmly secure by tightening the o-ring on the connector. Then place the remote control in the
remote pocket.
14. Connect the pillow sensor (x1) and the heat connectors (x2) by securing the electrical
connectors from the seat/back pad to those now located at the seat of the chair.
R.6 Massage Chair!
Assembly Instructions

16. Zip the leg rest to the seat pad located
on the base of the chair.
17. Turn on the main power switch located
on the back base.
15. Lay the seat pad down so it sits on the base of the chair. Then secure the back pad by
completing the zipper connections on the left and right side of the chair’s back, and secure the seat
pad by zipping it to the base of the chair.!
Note back pad zippers start at the top of the back and go down to the seat of the chair.
Note the seat pad zipper starts at the back left of the seat, wraps around the front of the chair, and
and ends at the back right side of the seat.
R.6 Massage Chair!
Assembly Instructions