Oklahoma Sound THE PRESTIGE LECTERN 711 User manual

THE PRESTIGE LECTERN
Sound Floor Lectern
PRODUCT HANDBOOK
MODEL #711

INTRODUCTION
The Prestige Lectern — Model 711
Abeautifully handcrafted podium that commands a dignified presence. Wide
reading surface illuminated by a recessed fluorescent lamp; also features sur-
face mounted digital timepiece. Self-contained solid-state multimedia amplifier
offers three mics and one line for CD/Tape play. Now also includes wireless
options built-in. Two line out jacks provide expansion possibilities for additional
speakers and tape recording; and sound may be customized via the full range
tone controls. Unit moves easily on four concealed easy roll casters; two lock-
ing. Colors: Walnut, Light Oak, Medium Oak or Mahogany.
Dimensions: 52”H x 26”W x 20”D.
CARE OF YOUR CABINET
All exterior and interior exposed surfaces are melamine covered as well as
edges in matching patterned melamine material. To refresh the appearance,
wipe the surface with a cloth soaked lightly in furniture oil. Avoid speaker grill
area.Your cabinet will look as good as new.
TECHNICAL SPECIFICATIONS
OKLAHOMA SOUND CORPORATION
2
Manufacturers Warranty
Our Lecterns undergo the most rigid and exacting tests for superior quality and performance before leaving the
factory.Oklahoma Sound Corporation warrants this product to be free from defective material and workman-
ship on the electronic product speakers and microphones for two years from the date of resale by an authorized
Oklahoma Sound distributor. Oklahoma Sound will replace defective parts and repair malfunctioning products
under this warranty when the defect occurs under normal installation and use, provided the unit is returned to
our factory via prepaid transportation after direct authorization and approval by Oklahoma Sound. This war-
ranty provides that examination of the returned product must disclose in our judgement, a manufacturing
defect. This warranty does not extend to any product which has been subject to misuse, neglect, accident,
improper installation, or where the serial number has been removed or defected and is given in lieu of any
other warranty implied or expressed and will not cover any consequential damages.
Power
Output........50W RMS at 10% THD
Mic..............Electret Condenser (2)
Aux..............150 mV>220K
Frequency...100HZ-25KHZ
Response... +3dB
Power
Supply ........110-120V ohms DC 10.8 12V
Fuse ............2A Normal
Output ......8ohms
Wireless frenquency
....................187,8275 MHZ 187,190MHZ
Accessories
Handheld mic; clip-on mic; gooseneck; Shockmount mic holder; digital clock

The Prestige Lectern • Model 711
3
700 SERIES WIRELESS AMPLIFIER OPERATING INSTRUCTIONS
Operating Precautions
Before operating the amplifier, be sure you fully understand all instructions and features of the
amplifier. DO NOT turn amplifier on until all input and output connections have been made.
NEVER replace fuses unless power is off.
Microphone Input Connection
The microphone input accepts 1⁄4" phone jack. Do not position microphone next to or facing
speakers. This may cause acoustic feedback.
Wireless Operation
Turn on the power on both the wireless receiver and wireless mic., making sure both are set to
matching channels, either “A” or “B”.
Auxiliary Input
One auxiliaryinput is provided for radio tuner, tape recorder, CD player or multi-media equip-
ment. Output level is adjusted by the auxiliary volume control.
Tone / Equalization Controls
The Low and High frequency controls are similar to the bass and treble controls found on most
stereo systems. Optimum tone is achieved by first setting both knobs halfway; adjust Low and
High frequency controls to suit environment.
Auxiliary/Line Out
Connect additional speaker line to navy line out connector of the amplifier. For maximum
power transfer and to avoid amplifier overload, be sure that the total impedance of the speak-
er line matches the output impedance setting on amplifier. Be sure that speaker terminals are
not shorted together by speaker line connecting cables. Can also be used for a recording
device.
Power Supply 12V DC Operation
Connect a 12 volt rechargeable battery 5 Amp (not included) to the battery input connector
located on the panel of the amplifier (using 6' battery cable). Be sure that the positive pole of
batteryis connected to the white wireterminal (+) and the negative pole to the Brass wire (–).
When lectern is plugged into a standard wall outlet, the battery will automatically recharge.
Green indicator light illuminates during recharge mode.
Precautions
• Set Mic volume control on lowest when turning unit on.
•Insurecorrect polarity for D.C. supply connections.
• Reverse connection will blow the fuse and may damage internal circuitry.
• Always replace fuse with specified rating.
Removal and Installation of Amplifier
If your amplifier has to be removed for servicing — follow these simple steps:
1) Disconnect A/C wall plug.
2) Remove 4 side screws two on each side panel under amp top.
3) Disconnect speaker wire at rear of amplifier.
4) Packit into a strong box with ample cushioning and return to factory.
5) Toinstall new amplifier reverse the above procedure.

OKLAHOMA SOUND CORPORATION
For these and other OSC accessories, please contact your dealer, or:
OKLAHOMA SOUND CORP.
149 Entin Road, Clifton, NJ 07014; Tel: [phone]• Fax: [phone]
Web-Site www.oklahomasound.com • e-mail: inf[email protected]
OPTIONAL/ADDITIONAL EQUIPMENT WITH WIRELESS AMPLIFIERS
Your lectern includes two corded microphones. For complete freedom of move-
ment, use any of these wireless systems—
HAND-HELD WIRELESS MIC. / LWM-5
This wireless hand-held Mic. Uses a 9-volt battery. Select
channel A or B to eliminate outside frequency interruption.
Move freely up to 200 ft. away!
TIE-CLIP LAVELIER WIRELESS MIC. / LWM-6
Includes pocket-size transmitter with a clip-on mic. Uses a 9-
volt battery. Select channel A or B to eliminate outside fre-
quencyinterruption. Move freely up to 200 ft. away!
HEADSET WIRELESS MIC. / LWM-7
Includes pocket-size transmitter with a headset mic. Uses a
9volt battery. Select channel A or B to eliminate outside
frequency interruption. Move freely up to 200 ft. away!
USE WITH NON-WIRELESS AMP
or ADDED WIRELESS USERS
TIE CLIP LAVALIER WIRELESS MIC SYSTEM / #WM-190TC
Acompact, pocket-size, wireless system with tie-clip,
lavalier type microphone. Includes transmitter, receiver and
tie clip mic. Movefreely up to 200 ft. Operates on
two 9V batteries.
WIRED-WIRELESS MIC SYSTEM / #WM-100H
Hand-held wireless mic system. Receiver has antenna and
on/off switch. Transmiter is built into mic. Move freely up to
50 ft. Mic uses AA battery; receiver uses AAA battery.
DUAL HAND-HELD WIRELESS MIC SYSTEM / #WM-200H
Offers freedom of movement for two people, Karaokee
style or speaker/audience participation; up to 200 ft. away.
Receiver operates on 110V AC. Each mic trans–
mitter uses one 9V battery (not Included).
12V LANTERN STYLE RECHARGEABLE BATTERY / #PS12V
12V 5 amp rechargeable battery pack w/included cable
connects to any of our lecterns for battery power. 20 hr life.