exit the system from Transmitter Programming Mode; in either case the system
signals the exit with 1 long siren chirp.
Installation
Page 21
Mounting The Main Control Module: The Main Control Module contains the
electronics necessary for the security system's operation. Always mount this
module in the vehicle's interior compartment, in a secure location that is not eas-
ily accessible. Ensure that moisture, vibration and temperature extremes are
minimized. Acceptable locations may include mounting behind the dash, behind
the glovebox or other interior panels.
Mounting The Siren: Find a location in the engine compartment away from the
extreme heat of the engine and manifold. A suitable location will offer a firm
mounting surface, will also allow sound dispersion out of the engine compart-
ment, and not be accessible to a thief. The siren must be pointed downward to
avoid moisture collecting inside it and to enhance sound dispersal.
Wiring Connections: The security system's wiresshouldbesecurelyconnected
to the appropriate vehicle wires with the proper terminals, connectors, or by
soldering and insulating with quality vinyl electrical tape or heat shrink tubing. All
wiring should be carefully routed to avoid the possibility of chaffing or otherwise
beingdamaged. Makeall required connections, then plug the harnesses into the
control module.
Installation
Page 22
Black Wire - (- Ground Input):
The Black wire's function is to supply - Ground,
which completes the circuitry and allows the security system to operate.
CONNECTION:Usingthecorrectsizedcrimp-onringterminal,connecttheBlack
wire to the metal frame of the vehicle, preferably using an existing machine-
threadedfastener. Make surethatthe ringterminalattached totheBlackwirehas
contactwithbright,cleanmetal. Ifnecessary,scrapeanypaint,rustorgreaseaway
from the connection point until the metal is bright and clean. If the control module
has an insufficient ground connection, the security system can find partial ground
throughthewiresthatare connectedtoothercircuits,butthealarmwillnotfunction
correctly, giving the impression of a defective control module. The system can
partially work, so a bad ground wire connection would be suspected. In some
cases the alarm could arm and disarm properly -but not function
correctly otherwise.
The Black wire attached to the control module is the antenna wire. Do not
connect this wire to anything or the transmitter's range will be reduced or
eliminated. StretchtheBlackantennawireoutandashighaspossibleforthebest
operatingrange.
Red Wire - (+12 Volts Input): The Red wire's function is to supply Constant
+12 Volts to the security system. When +12 Volts is first applied to the Red wire,
Wiring Connections
Page 23
the system will revert to the state it was in previously. The Red wire also supplies
+12 Volts to the built-in relay for flashing the parking lights.
CONNECTION:ConnecttheRedwiretoasourcewhichhas+12Voltsatalltimes.
Ensure that this source +12 Volts which is stable in all ignition key positions.
Connectionlocationscanbeatthesupplywireattheignitionswitch,thesupplywire
behind
the fuse block or the fuse/junction block.
Never
just insert the Red wire or
any other security system wire behind a fuse. Also, please note that connecting
directly to the battery's Positive terminal will expose this connection to failure due
to a corrosive environment. The source connection must have at least a 15 Amp
capacity at all times.
YellowWire -(+12 VoltsIgnitionInput): TheYellowwireisanignition"on"input
to the security system. This connection is critical to the proper operation of many
of the security system's operations.
CONNECTION: This wire supplies +12 Volts to the control module whenever the
ignition switch is "on". This connection should be made at the ignition switch
harness,totheprimaryignitioncircuit. Primaryignitionhas0Voltswhentheignition
keyisinthe "Lock","Off"and"Accessory"positions;and+12Voltsinthe"Run"and
"Start"positions. Locatethecorrectwireattheignitionswitchharnessandsecurely
splice the Yellow wire to it. This connection is critical to the proper operation of
"Enhanced 3rd Channel Operation", which is explained in the Owner's Manual.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions, (1) This device may not cause harmful interference and, (2) This device must accept
any interference received, including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the
equipment.
Products manufactured and sold by OMEGA RESEARCH & DEVELOPMENT, INC. (the Company), are
warranted to be free from defects in materials and workmanship under normal use. If a product sold by
the Company proves to be defective, the Company will repair or replace it free of charge within the first
year and thereafter all parts to be repaired will be free with only a nominal charge for Omega Research
and Development, Inc.'s labor and return shipping, to the original owner during the lifetime of the car in
which it was originally installed.
All products for warranty repair must be sent postage prepaid to Omega Research & Development, Inc.,
P.O.Box508,Douglasville,Georgia30133,withbillofsaleorotherdatedproofofpurchase.Thiswarranty
is nontransferable and does not apply to any product damaged by accident, physical or electrical misuse
orabuse,improperinstallation,alteration,anyusecontrary toits intendedfunction, unauthorizedservice,
fire, flood, lightning, or other acts of God.
ThiswarrantylimitstheCompany'sliabilitytotherepairor replacementoftheproduct.The Companyshall
not be responsible for removal and/or reinstallation charges, damage to or theft of the vehicle or its
contents,oranyincidentalorconsequentialdamagescausedbyanyfailureorallegedfailureoftheproduct
to function properly. Under No Circumstances Should This Warranty, Or The Product Covered By It, Be
Construed As A Guarantee Or Insurance Policy Against Loss. The Company neither assumes nor
authorizes any person or organization to make any Warranties or assume any liability in connection with
the sale, installation, or use of this product.
L I M I T E D L I F E T I M E W A R R A N T Y
MA_K9-Mundial/REV1 7/00