Openplan A22 Aspire User manual

www.openplan.com | [email protected] | 844.OPS.OPS1 | REV 12.05.19 1
A22 ASPIRE
ASSEMBLY GUIDE
STEP 1:
1. Insert 5 casters onto base
2. Insert gas lift into base
STEP 2:
1. Insert seat into gas lift
STEP 3:
1. Insert armrests into the seat
2. Tighten screws
STEP 4:
1. Insert assembled back into the seat
2. Tighten screws
Maintenance and Attention
1. Make sure the chair can only carry
one person at a time.
2. Do not use the chair as a step stool or
ladder.
3. Do not use the chair before all parts
are properly assembled.
4. Do not use chair unless all screws
have been tightened.
5. If destroyed by outside forces or
defect work, stop use the chair until
repaired.
6. For your safety, the instructions listed
above must be strictly observed.
1
2
3
4
58
6
7
10
9
Gas Lift Armrest Type B Back Screws
Base
Casters (5) Armrest Screws
Seat Allen Wrench
Assembled Back
1
2
3 6 9
47
58

www.openplan.com | [email protected] | 844.OPS.OPS1 | REV 12.05.19 2
A22 ASPIRE
USER GUIDE
Armrest Adjust:
1. The height of the armrest can be
adjusted freely by pressing the button
under each armrest.
2. Armrest can adjust in/out manually.
Seat Height and Tilt angle Backrest:
1. Adjust the height of the backrest up
and Down.
2. It has five positons. It will drop to the
lowest position automatically after
raising it to the highest position.
3. Please adjust the height
to the most comfortable
position.
Height of Lumbar Support
1. The lumbar support could be up and
down manually by pulling the handle
(Some models are without tandem function)
Seat Height Adjust:
1. Press the second button under the left
side to adjust the appropriate height.
2. The height can be fixed after
unclenching your hand.
Seat depth:
1. Press the buttion to adjust seat slide forward
and backward, and release the button to fix
the seat depth.
Elasticity of Tilting:
1. A handle under the button seat could adjust the
elasticity degree of the backrest.
2. The elasticity could be increased by moving the
handle clockwise.
3. The elasticity could be decreased by moving the
handle anticlockwise.
Radian of Tilting:
1. Press the button under the left side could adjust and lock the
radian of backrest.
2. Turning the button up is free state. We can adjust radian of
backrest by moving out body.
3. Turning the button up so that the radian of back rest can be fixed.
4. Four positions tilt adjustable.
5. Restore the backrest position after turning the button up and
moving body back again.