Opticon EBS-40 User manual

EBS-40
Quick Start Guide
DC Power
Reset Switch
Package Contents
• EBS-40 Base Station
• Antenna (2)
• Quick Start Guide
EBS-40 Quick Setup
1. Connect power (power supply sold
separately).
2. Plug your network cable into Ethernet
Port 1. The other port can be used to
daisy chain additional EBS-40 units.
3. DHCP is enabled by default.
4. If no DHCP server is available then the
EBS-40 will use the default IP address
and subnet which can be found on the
label on the bottom.
5. Network settings can be changed via
the built-in web page, accessable via the
assigned (or default) IP address.
Ethernet Port 1
Ethernet Port 2
www.opticon.com

Handle this product carefully. Do not
deliberately subject it to any of the following.
Use common sense when handling this product.
General
• Do not use this product for any unintended
purpose.
• Do not use this product outside its operating
tolerances.
• Do not expose this product to extreme heat,
cold or moisture.
• Do not disassemble this product.
Electrical
• Power this product only with an approved
power supply.
• This product requires external surge
protection.
• Do not handle the base station if there is risk
of electrical shock.
Impact
• Do not drop, throw or crush this product.
• Do not stack objects on top of this product.
Safety
_QSG_EBS-40_03-2022
LEDs
Two large LEDs sit on the top surface of the
EBS-40. The power LED is a steady red while the
unit has power. The data LED will blink green to
indicate data is being transported across the ESL
network.
Opticon Sensors Europe BV
Opaallaan 35, 2132 XV Hoofddorp, the Netherlands