OPTIMEO Opti-1 User manual
Optimeo folds in 4 parts for your comfort at work
DESIGNED IN FRANCE
REGISTERED DESIGN
01
Put the document holder at
with the blank cardboard facing
upwards. Fold the two external
aps as shown (green dots).
02
Raise the aps 90°
(green dots).
03
Fold them against the back
(the side edges are raised)..
ASSEMBLY
INSTRUCTIONS
for the Opti-1 ergonomic
document holder
04
Hold the aps in place and lift the
lower section 90°.
05
Start folding the lower section
while folding the two internal
aps (green dots).
06
Finish folding the lower section
by pressing on the edge you have
created.
07
Firmly close the edge and
move the central ap (with
the arches) towards you 90°.
08
Hold the central ap while
folding the two side aps inside.
09
Insert the tabs into the slots.
CONTACT US TO ORDER
+33 (0)6 95 11 37 68
contact@optimeo-prevention.com
www.optimeo-prevention.com
Place the document holder directly onto your work surface (if necessary remove anything in the way, such
as a calendar, etc). Run any cables there may be under the document holder arches. Do not forget to fold
away the feet at the back of your keyboard.
10
Fold the two external aps as
shown (green dots).
11
Lift then fold the ap against the
back of the document holder.
12
Push the ap against the arches.
13
Fold the two side aps
towards the inside. Insert
the tabs into the slots.
14
Turn the document holder
over and press lightly on the
edges to nish assembly.
15
Your document holder is ready
for use. The user instructions are
shown on the back.
We hope you enjoy working with the benefit of the Opti-1!
Ne pas jeter sur la voie publique • Octobre 2019 • OPTIMEO PREVENTION • SASU au capital de 1 000 € • RCS NANCY 827972803 • Crédit photo Optiméo Prevention • Conception AgenceSW.com 03 72 47 01 66
Watch the assembly how-to video here:
https://www.optimeo-prevention.com/opti-1-montage or scan the QR code shown opposite.
