
Function Setting
功能設定
4
1.
1. Place the Fan on a stable and flat surface. Plug the Power Cord into an 220-240V~
50-60Hz electrical outlet.
5. 左右送風: 按下左右送風鍵 ,風扇以自動左右搖擺模式送風。如欲停止自動左右搖
5. OSC(LEFT/RIGHT): Press the key to allow the Fan to LEFT/RIGHT oscillate the
擺送風,再按此鍵一次。
wind direction. To stop the oscillation, press the key again.
將風扇擺放於穩固的平面上,將插頭插入交流電壓220-240V~50-60Hz的獨立插座,
3. 風速: 按風速設定鍵 ,設定所需風速:低、中、高、或超強。LED顯示燈將會顯示風速。
風扇可使用控制面板按鍵操控(如圖1),或改用遙控器操控。
3. SPEED: Adjust the Fan speed to the desired level: Low, Medium, High or Gale
by pressing key. The speed setting is displayed on the LED light.
2.
2. POWER: Turn the Fan ON by pressing the key, the Fan start at low speed.
圖1
Figure 1
開/關:按開/關鍵 ,風扇以低檔啟動。
The Fan may be operated by the control panel (as shown in Figure 1) or by your
remote control.
Hour
11
44
22
NN
SS
開/關
定時 風速 左右送風
上下送風 送風模式 TIMER ON/OFF SPEED L/R OSCU/D OSC MODE
4. 上下送風: 按下上下送風鍵 ,風扇以自動上下搖擺模式送風。如欲停止自動上下搖
4. OSC(UP/DOWN): Press the key to allow the Fan to UP/DOWN oscillate the
擺送風,再按此鍵一次。
wind direction. To stop the oscillation, press the key again.
立體搖擺對流扇
4D convection fan
6. 前網旋轉: 當風扇關閉時,逆時針旋轉前網旋轉鎖以鬆開前網,但請不要卸下旋轉鎖。
按開/關鍵 啟動風扇,將風速設置為超強速,前網將開始旋轉。如欲停止前網旋轉,
請先關閉風扇並順時針旋轉前網旋轉鎖並扭緊以鎖定前網。
注意:當前網旋轉時,請勿觸摸前網或前網旋轉鎖,以免發生意外。
6. FRONT GRILL ROTATION: Turn the Front Grill Revolving Ring anti-clockwise to loosen
the front grill when the Fan is off, but please do not remove the Revolving Ring.
Turn the Fan on by pressing the key and set the speed at Gale level, and the
Front Grill will start to rotate. To stop the rotation, turn off the Fan and turn the
Front Grill Revolving Ring clockwise and tighten it to lock the front grill.
Notice: Do not touch the front grill or turn the Revolving Ring while operating the
front grill rotation, this may cause injury.