Osmond Ergonomics BODYBILT S2504 User manual

BODYBILT (S2504 & S3504) - INSTRUCTIONS
1.
SEAT HEIGHT
2. BACK ANGLE
3. FREE FLOAT ACTIVATION
Lift the middle lever on the right-
hand side and take your weight off
the seat to raise the height. Remain
seated to lower the height. Release
the lever to lock the seat height.
Lift the back lever on the right-hand
side and take your weight off the
back to bring it forward. Lean back
to move it backwards. Release the
lever to lock the back angle.
Lift the front lever on the right-hand
side to activate the seat rock. Push
the lever back down to lock the seat
in any position.
4. FREE FLOAT TENSION
5. BACK HEIGHT
6. LUMBAR PUMP (IF FITTED)
Twist the knob on the underside of the
chair while in seat rock mode to adjust
the tension of the rocking motion.
Anti-clockwise reduces the tension,
clockwise increases the tension.
First, raise the back to its highest
setting, and then lower it to its lowest
setting. Then lift the back one click at
a time (7 clicks maximum) to the
desired position.
Squeeze the bulb repeatedly to inflate
the lumbar support. Press the button
on the bulb to deflate.

7. SEAT DEPTH
8. ARM REST HEIGHT
9. ARM REST (IF FITTED) DEPTH
Lift the lever on the left-hand side
and slide the seat backwards or
forwards. Release the lever to lock
the seat slide.
Lift up and hold the lever on the arm
post to release the arm height lock.
Raise or lower the arm. Release the
lever to lock the arm height. Repeat
for the other arm.
Slide the arm-top forward or
backward. Repeat for the other arm.
10. ARM REST WIDTH
Twist the knob at the base of the arm
to loosen the arm width lock. Slide the
whole arm in or out. Twist the knob
back again to lock the arm. Repeat for
the other arm.