Osmond Ergonomics Axia Profit User manual

AXIA PROFIT - INSTRUCTIONS
1.
SEAT HEIGHT
2. SEAT TILT ADJUSTMENT AND
FREE FLOAT ACTIVATION
3. FREE FLOAT TENSION
Lift the middle lever on the right or
left-hand side and take your weight
off the seat to raise the height.
Remain seated to lower the height.
Release the lever to lock the seat
height.
Lift the front lever on the right or
left-hand side to release the seat tilt
lock. Tilt the seat while seated.
Release the lever to lock the seat tilt.
Or push down the front lever to
activate the seat rock. Lift the lever
back up to lock the seat in any
position.
Twist the knob on the underside of
the chair while in free float mode to
adjust the tension of the rocking
motion. Clockwise increases the
tension, anticlockwise reduces the
tension.
4. BACK HEIGHT
5. SEAT DEPTH
6. ARM REST (IF FITTED) WIDTH
Twist the left and right knob on the
back mechanism in the same direction
simultaneously to adjust the back
height.
Ensure the seat is tilted fully forward.
Pull out either the left or right lever at
the back corner of the seat and slide
the seat forward or backward. Release
the lever to lock the seat depth.
Loosen the screw at the base of the
arm to loosen the arm width lock.
Slide the whole arm in or out. Tighten
the screw back again to lock the arm.
Repeat for the other arm.

7. ARM REST (IF FITTED) HEIGHT
8. ARM REST (IF FITTED) DEPTH
9. ARM REST (IF FITTED) ANGLE
Push in and hold the button on the
underside of the arm to release the
arm height lock. Raise or lower the
arm. Release the button to lock the
arm height. Repeat for the other
arm.
Slide the arm-top forward or
backward to achieve the desired
depth. Repeat for the other arm.
Rotate the arm until it locks at the
desired position. Repeat for the
other arm.