Osmond Ergonomics Adapt 600 User manual

ADAPT 600 - INSTRUCTIONS
1.
SEAT HEIGHT
2. BACK ANGLE
3. FREE FLOAT ACTIVATION
Lift the middle lever on the right-
hand side and take your weight off
the seat to raise the height. Remain
seated to lower the height. Release
the lever to lock the seat height.
To adjust the angle of the backrest,
lift the rear lever on the right-hand
side and lean the backrest to the
desired position. Return the lever to
the downward position to lock the
backrest in place.
Lift the forward-most lever on the
right-hand side to activate the free
float. Lower the lever to lock the seat
in to position.
4. BODY WEIGHT TENSION
5. BACK HEIGHT
6. LUMBAR SUPPORT
To adjust the body weight tension, twist
the knob on the right hand side. Rotate
clockwise to increase the tension,
rotate anti-clockwise to reduce the
tension.
To adjust the height of the backrest,
grasp the bottom of the backrest
and raise to the desired height. To
allow the backrest to be lowered
again, raise the backrest all the way
to the top and lower it to its lowest
position.
As you are sitting on the chair
squeeze bulb, located underneath
the left-hand side of the seat,
repeatedly to inflate the lumbar
support. Press the button on the
bulb to deflate the lumbar support.

7. SEAT DEPTH
8. ARMREST HEIGHT
9. ARMREST DEPTH (IF FITTED)
Lift the lever on the rear left-hand
side and slide the seat forward or
backward. Release the lever to lock
the seat depth.
To adjust the height of the armrest
press the button on the side of the
armrest and lift or lower to the
desired position. The armrest will
lock in to a total of six different
heights.
To adjust the depth of the armrest
slide the armrest either forwards or
backwards until it reaches the
desired depth.
10. ARMREST WIDTH
To adjust the armrest width, loosen
the handle on the underside of the
chair by turning it anti-clockwise and
position the armrest to the desired
width. To lock the arm rest in position
tighten the handle by turning it
clockwise.
11. ARMREST FOLD (IF FITTED)
12. HEAD/NECK SUPPORT
To fold away the armrest, press the
button at the bottom of the armrest
and fold away the armrest to the rear
until it locks into position. To return
the armrest to its original position,
press the same button and rotate the
arm until the button locks back into
its upright position.
Pull the head/neck support post
up to the raise the height or push
it down to lower the height. Rotate
the cushion up or down for varying
support.