Osram ENCELIUM EDGE User manual

ENCELIUM EDGE™Controller
Power Supply Unit
Wiring and installation guide
www.osram.us
Light is OSRAM

Overview
The ENCELIUM EDGE™Controller Power Supply Unit comes with the following
power ratings:
—Input Power: 120-347 Vac
—Output Voltage: 42-48 Vdc, typical 45 Vdc
—Output Current (typical): < 60 mA
—Output Power: 3W max.
Shown below are the ENCELIUM EDGE Power Supply Unit’s top and bottom views:
Important Safeguards
When using electrical equipment, basic safety precautions should always
be followed including the following:
—READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
—Do not mount near gas or electric heaters.
—Equipment should be mounted in locations and at heights where it will not
readily be subjected to tampering by unauthorized personnel.
—The use of accessory equipment is not recommended by OSRAM as it may
cause an unsafe condition.
—Do not use this equipment for other than the intended use.
SAVE THESE INSTRUCTIONS
Note
Tip
!
STOP
2
PoE Cable to/from
ENCELIUM EDGE Controller AC Line Input
Top View Bottom View
Note
Tip
!
STOP

Junction Box Installation
Attach ENCELIUM EDGE™Controller Power Supply Unit to a NEMA approved
Junction Box.
3
Power Supply wires
from ENCELIUM EDGE Controller
Power Supply Unit
AC Line Input to
ENCELIUM EDGE
ControllerPower
Supply Unit
Power Supply wires
from ENCELIUM EDGE Controller
Power Supply Unit
AC Line input to
ENCELIUM EDGE
Controller Power
Supply Unit
ENCELIUM EDGE Controller Power
Supply Unit - Junction Box
connection details
PoE Cable to/from
ENCELIUM EDGE Controller
AC Line Input to
ENCELIUM EDGE
Controller Power Supply
PoE Cable Installation
Attach PoE cable to the ENCELIUM EDGE Controller Power Supply Unit.

© 2017 OSRAM SYLVANIA Inc.
LMS114R1 10-17
Installation Notes
Consult OSRAM website at www.osram.us/partner-resources for the most
up-to-date revision of the ENCELIUM EDGE™System design guide and install
this product according to the guidelines described.
Troubleshooting
There are no user-serviceable parts inside the ENCELIUM EDGE Controller
Power Supply Unit. Please return the device to OSRAM if service is required.
Regulatory Approvals
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Modifications not expressly approved by the manufacturer could void the user’s
authority to operate the equipment under FCC rules.
This equipment has been tested and found to comply with Industry Canada
ICES-003 Issue 5 (CAN ICES-3 (A)/NMB-3(A)).
OSRAM SYLVANIA Inc.
200 Ballardvale Street
Wilmington, MA 01887 USA
888-531-7573
www.osram.us/ds
OSRAM is a registered trademark of OSRAM GmbH.
ENCELIUM EDGE is a trademark of OSRAM SYLVANIA Inc.
Specifications subject to change without notice.