Outsunny 840-232 Installation guide

ASSEMBLY & INSTRUCTION MANUAL
READ AND SAVE THIS INSTRUCTIONS FOR FUTURE USE
INboc021_US_UK
840-232
Assembly video please scan the QR code .
Tools Recommended

PART
LIST
M8*75
M6
M8
M6*40
H 4
G 4
F 4
E 4
D 8
C 2
B 1
A 1
Warning: When mounting the awning, keep the cassette part and stand column on
the horizon, or the fabric will deformation and difficult to open and close.

02
01
1.Drill 6cm deep holes in the size as the following picture shows
2.Insert oneφ10x50mm plastic expansion tube in each of holes.

04
03
3.Fix the bracket with M6x60 hexagon tapping bolt
4.Insert the cassette part into the bracket, tighten the flat fillister head screw
M6x16mm with Hexagonal spanner CR-V5mm

06
05
5.Drill four 10mm diameter holes on the floor in the size as the following picture
shows
6.sert one φ10x50 mm plastic expansion tube（4pcs）in each of holes

08
07
7.Make the left bottom hole of stand column and the hole on the floor alignment, and
tighten them with M8x75 hexagon tapping bolt.
1.Keep the front bar upright, hold the handle and pull it over the column. Hold the
handle tightly, rotate it 90 degrees, align the side of the front rod with the groove of
the column and put it in, so that the main shaft of the handle can be clamped into the
groove. See the figure below for details
CORRECT USE

09
2.Before closing, pull it out first, then rotate it 90 degrees to make the side of side
bar align with the groove, and then close it slowly
Done