
4 EN | OP-24 Plus preamp
position increases the energy contained within that spectrum. Likewise, moving the
control below the center position decreases the signals within that band.
The OP-24Plus preamp offers ± 12dB control simultaneously over three discrete
ranges of the guitar‘s sonic spectrum. In addition, with the Mid-Shift switch, you can
change the center frequency of the Mid EQ control by roughly one octave.
The Low EQ control allows you to increase or reduce the sound in the bass region.
Raise this control above the center position to add fullness or bottom to your sound.
De-amphasizing this band results I a lighter, less ponderous sound quality.
The High EQ control performs similarly to the „Low“ control except that its effect sha-
pes the high frequency, or treble band. Increase this control for bright or airy sounds,
or decrease for darker or round tonalities.
Much like the High and Low controls, The Mid-band control adds coloration to one
of two user-selectable midrange frequencies. With the Mid-shift switch in the 400Hz
position(down), the mid EQ is effective controlling „nasal“ tone qualities while in the
1KHz position, the mid control can add punch in upper mids or help „round off“ the
attack present in this frequency spectrum.
4. EQ In/Out
This push-button enables you to engage or defeat the EQ section. When the switch is
in the depressed position, the EQ is active.
5. Mid-Shift
As discussed above, this switch allows you select the center of the frequency band in
which you would like th Mid control to operate.
6. Pre-Shape
By engaging this control (switch in the „down“ opsition), you add a fixed EQ curve on
the sound from the pickup. Technically speaking, when the pre-shape circuit is in
operation, the bass and treble frequencies are enhanced while at the same time, mid
range response is attenuated. This pre-emphasis can be used alone, or with any other
EQ setting you „Dail in“ with the three EQ controls.