OYPLA Home 3769 User manual

8.5L Digital Steel Safe
User Manual
USER MANUAL Model No: 3769

USER MANUAL Model No: 3769
•This product is not a toy, and is only to be used for its designated purpose.
•DO NOT close the safe door unless the keys have been removed and batteries are in
the keypad panel.
•This product is intended for indoor use only.
•Do not carry out alterations or modifications to this product.
•This product contains small parts that could be a choking hazard if swallowed. Keep
these items away from children.
•Do not discard any of the packaging until you have checked that you have all the
parts and fittings required.
•Never lock your spare override keys or the instruction manual in the safe. Once the
batteries have depleted, you will need to use the keys to open the safe. Spare keys
are not available.
•Clean only with a damp cloth. Do not use strong industrial cleaning substances or
abrasive materials as these will damage the product.
•If the product is damaged or has any defects, please contact [email protected]
Please retain a copy of all instructions for future consultation.
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold on
this condition, which no representative of the company can waive or change.

USER MANUAL Model No: 3748USER MANUAL Model No: 3518USER MANUAL Model No: 3769
Operating Instructions
Parts List:
If you are missing any of the below parts please contact [email protected]om
Please be aware that you will be referring to this parts list throughout the assembly
process.

Operating for the first time:
• Remove the plastic lock cover.
• Insert the override key, turn it anti-clockwise and at the same time turn the locking knob
clockwise and pull open the safe.
• Remove the battery cover on the rear of the door by pushing the catch and pulling out the cover.
• Keep the door open until you have set the PIN code.
Inserting/Replacing Batteries:
• Remove the battery cover on the rear of the door
by pushing the catch in and pulling out the cover.
• Install the four AA batteries, ensuring they are in
correctly. Put the cover back on.
• Keep the door open until you have set the PIN
code.
The battery life is approximately one year.
If the batteries are removed from the safe, the set
PIN code will only remain in its memory for
approximately four hours. After this the PIN code will
need resetting.
USER MANUAL Model No: 3769

USER MANUAL Model No: 3769
Programming your PIN:
Each time a button is pressed, a beep will be
heard and the orange LED will flash. This is a
safety feature so you will know when the safe is
being accessed and cannot be switched off.
Keep PIN codes in a safe place. Do not use
personal information like birthdays, telephone
numbers etc.
•Write down your PIN code so you do not
forget it. (Any combination of numbers from
three to eight digits).
•Press the red reset button located on the back
of the door.
•A beep will be heard and the orange LED will
light. This means you have twenty seconds to
enter your PIN.
•After entering your new PIN, press the “A” or
“B” button once.
•A beep will be heard and the orange LED will
go out.
•Your PIN has now been set.
•Screw the security cap back onto the red reset
button. Be sure to do this to avoid people
tampering with the safe.
Opening the door using your PIN number:
Each time a button is pressed, a beep will be
heard and the orange LED will flash.
•Enter your PIN number.
•Press the “A” or “B” button.
•A beep will be heard and the orange LED will
flash.
•The green LED will light to indicate that the
safe door can be opened.
•You now have five seconds to open the door
before it will lock again.
•Open the safe door by turning the knob
clockwise and pulling it open.
If the red and green LED lights flash when the
correct PIN is entered, then the batteries MUST
be replaced immediately before closing the
door as this indicates that the batteries are too
low.
If you enter an incorrect PIN, three warning
beeps will be heard. Entering an incorrect PIN
three times will freeze the locking mechanism
and keypad for twenty seconds. If you enter the
PIN incorrectly another three times, the same
will happen but for five minutes.
Securing your safe:
NOTE: We strongly recommend securing your
safe to a wall or floor for security reasons.
•To secure the safe to the desired surface,
start by using the holes in the safe to mark out
where you need to drill.
•Loosely attach the rawl bolt onto the safe
with the nuts and washers provided.
•Hold the safe over the drilled holes and
insert the rawl bolts into the holes (as seen in
the image to the right).
•Tighten the nuts from the inside of the safe
to secure it firmly into place.

USER MANUAL Model No: 3769
Can I get a replacement key/
extra key?
Replacement keys are not
available as the keys are
unique to each safe.
The keypad becomes
inoperable.
Low or fully depleted batteries.
Use the override keys and
replace the batteries.
My PIN works and the green
light lights, however, the safe
won’t open.
The batteries are low. The
keypad will operate but the
lock relay won’t.
Use the override keys and
replace the batteries.
I have lost the keys and
forgotten the PIN number, can
I get some spare keys?
If the safe cannot be opened
properly then you will need to
forcibly open it
I am experiencing problems
using the backup key; it is
unable to slide smoothly into
the keyhole.
Spray inside the keyhole with
WD40, leave for a few minutes
and then try again.
We recently changed the
batteries in the safe, the safe
has reset the code itself, and
the code I’ve been using is no
longer valid?
If the batteries are completely
depleted for more than four
hours, the safe will not retain
the code.
Try the factory default code
(159) or use the override key;
then refer to the user manual
to reset your original code or
to enter a new code.
The Red and Green LED lights
simultaneously when the correct
PIN is entered.
The batteries are depleted.
Immediately replace the
batteries.
The batteries I bought don’t fit
the safe?
Batteries can vary in size.
Try another brand of batteries.
When I use the override key, I
can’t open the door.
Ensure that you are turning the
key anti-clockwise, holding it in
that position and then turn the
locking knob clockwise to
release the catch.