Oypla 4641 User manual
Page 1
Model Code: 4641
Oypla.com LLP / www.oypla.com
User Manual
Model Code: 4641
Contents
1Front Cover
-
2Safety
Instructions
-
3Operating
Instructions
-
4Back Cover
End
3 Ton Jack Stands
Page 2
Model Code: 4641
Oypla.com LLP / www.oypla.com
Contents
1Front Cover
-
2Safety
Instructions
-
3Operating
Instructions
-
4Back Cover
End
Safety Instructions
Notice: Ensure you read and fully understand instructions before use
While every attempt is made to ensure the highest degree of protection in all equipment, we cannot
guarantee freedom from injury. The user assumes all risk of injury due to use. All merchandise is sold
on this condition, which no representative of the company can waive or change.
•This product is not a toy, and is
only to be used for its
designated purpose.
•Never carry out any alterations
or modifications to this
product.
•Only use this product on stable,
level and dry ground.
•Always keep your hands and
feet away from the immediate
working area.
•Before using the product, make
sure all fastenings are tightly in
place and that everything is in
order, and checked
periodically.
•Leaving this product outside
exposed to weather, especially
direct sun, rain and salt air, will
speed with the weathering
process. This can be slowed by
removing the product from
these conditions, or covering it
with a suitable cover.
•When not in use the lift must
be stored in the lowest position
n in a dry location.
•This product is not intended for
use by persons (including
children) with reduced physical,
sensory and mental capacities,
or lack of experience and
knowledge, unless they have
been given supervision or
instruction concerning use of
the product by persons
responsible for their safety.
•Clean only with a damp cloth.
Do not use strong industrial
cleaning substances or abrasive
materials as these will damage
the product. Do this regularly
to keep the product clean of
any oil or grease.
•If the product is damaged or
has any defects, please contact
Page 3
Model Code: 4641
Oypla.com LLP / www.oypla.com
Contents
1Front Cover
-
2Safety
Instructions
-
3Operating
Instructions
-
4Back Cover
End
Operating Instructions
Please refer to the diagram below for instructions on how to operate your product.
1. Refer to your vehicle owner’s manual for the correct
jack lifting point. This area of the vehicle should be
specified by the vehicle manufacturer.
2. Position the stands under vehicle at points specified
by vehicle manufacturer.
3. To adjust the stands, hold the control lever up while
lifting saddle shaft to the desired height. Push the
control lever downwards to lock pawl into teeth
located in central column. Make sure the pawl is fully
engaged with the teeth.
4. Carefully lower the load onto the stands.
Page 4
Model Code: 4641
Oypla.com LLP / www.oypla.com
Contents
1Front Cover
-
2Safety
Instructions
-
3Operating
Instructions
-
4Back Cover
End
Other Oypla Jack manuals
