P.AP. Team THOR202 User manual

ank you for purchasing a PAP machine and trusting in our experience.
is will let you achieve and experience ight in a very simplistic form
and let those childhood dreams of ight become a reality. If you do not
want this dream to become a nightmare then please read and understand
fully the following recommendations about its operation and use.
Enjoy your machine and always respect the ight rules.
PARAMOTOR
USER MANUAL
THOR202

INSTRUCTIONS WHEN RECEIVING THE THOR202 ENGINE
1
DON’T FORGET TO
ATTACH THE SECURITY
STRAP OF THE AIRBOX
TO THE ENGINE SUPPORT
PLATE (fig 6)
(g 01)
(g 02)
(g 03)
(g 05)
(g 04)
(g 06)
When receiving your paramotor with the
Thor202 engine you will have to reinstall
the radiator on his support tight in the
6mm bolt (g 1).
Then you will have to connect the long
tube to the pump (g 2) and the other
one on the Top of the head cylinder (g
3): take care not to loose or damaged the
O ring gasket (g 4).
Everything is connected so now you have
to fill the circuit with aluminum radiator
liquid which can be found in gas station
and motorbike shops.
The amount is approximately 0,8 L.
You will have to fill until 2cm from the
aluminium grey part, 4cm from the top
(fig 5)
After starting the radiator, open the bottle
to control the cooling liquid level.

1
o
3
o
5
o
2
o
4
o
6
o
Like this we receive the engine.
We place the central bolt for the propeller support.
We leave the screws loose for the next step.
We place the central bolt for the propeller support.
We place the 6 propeller screws without tightening them.
We use a tubular bent key of 19mm. which is the only key that
will let you fasten with strength without damaging the central bolt.
ASSEMBLY PROPELLER POLINI THOR202 & THOR250
2

8
o
*
7
o
9
o
Fasten *anti clockwise while we hold the propeller with our other hand.
Fasten the 6 screws of the carbon propeller at 0.8 Kgm (8Nm).
Serial number of the Polini engines
Ready for flight. Its normal that there is small space no
bigger than a millimeter.
DO NOT USE ANY OTHER KEY TO FASTEN FOR NOT DAMAGING
THE CENTRAL BOLT AND BE ABLE TO TIGHTEN WITH STRENGHT.
THOR202
The tightening will be clockwise for the engines
with serial numbers from 783 to 1591.
The tightening will be anti clockwise for the
engines with serial nº 1592 onwards.
THOR250
The tightening will be clockwise for the
engines with serial nº until no1689.
The tightening will be anti clockwise for the
engines serial nº 1690 and onwards .

See manual of the Polini Thor 250
For information about the running of the engine, fuel recommended, reductor oil, maintenance, warranty, etc.
WATER RADIATOR TEMPERATURE SENSOR
4
If you have the option
of the TTO for liquid
temperature, you will have
to connect the plug after
installing the radiator.
ONLY IN ENGINES WITH FLOAT CARBURETOR ( THOR80 / 202 / 250)
GASOLINE TAP
3
CLOSE WHEN
TRANSPORTING
THE PARAMOTOR
IS LYING DOWN.
OPEN CLOSE
STARTING TECHNIQUE WITH FLASH STARTER.
5
These starters are a little more fragile than the conventional starters if not used correctly.
The strong dry pull is absolutely prohibited the movement should be a stretch of the arm in two times.
Pull the pulley slowly until bringing the piston to its point of compression, let the pulley go back and immediately
pull the pulley to unroll completely. It’s possible to have to repeat this various times for the engine to start.