Paasche Airbrush HG-08A User manual

INSTRUCTION MANUAL
HG-08AHVLP SPRAY GUN
INSTRUCTION MANUAL HG-08A 11-5-2018
Description:
HG- Manual Spray Guns are for use
from Low to Medium Pressure with
Light to Medium. They will cover a
range of materials to include enamels,
latex, lacquers, acrylics etc. These
Models require 2 to 4 C.F.M. at 20-
40 lbs. Air Pressure depending on
thickness of Material being sprayed.
Tip and needle are made of Stainless
Steel and can handle water or solvent
based materials.
Specication:
Part Number:
Type:
Head Size:
HG-08A
HVLP Gravity Feed
.8mm (Optional sizes .5mm & 1mm)
Air Volume: 2-4 CFM
Air Pressure: 20-40 PSI
Air Inlet: ¼” NPT thread
Cup size: 3 oz (27SC) - (Optional 8oz (28SC)
Spray Pattern: 1” to 7”
Weight: .90 Lbs
Finish: Blue / Silver
Setup:
1. Blow out all airline hoses before connecting to the spray gun
to remove foreign particles.
2. Connect air hose to air inlet tting.
3. Connect uid cup or uid hose to uid inlet.
4. Tighten all hose connections securely.
5. Adjust air pressure to required amount at the regulator.
6. Adjust uid volume by turning the uid control knob.
7. The Fan pattern is controlled by turning the fan control Knob
8. Test spray on some cardboard or news paper for nal
adjustment before spraying your project.
Paasche Airbrush Company
9511 58th Place
Kenosha, WI 53144
Ph: 773-867-9191 • Fax: [phone]
Website: www.paascheairbrush.com
E-Mail: [email protected]

2
WARNING: Spray materials may be harmful if inhaled or allowed to
come into contact with the skin or eyes. Consult the product label
and Material Safety Data Sheet supplied for the spray material.
Follow all safety precautions.
CAUTION: Well ventilated area required to remove fumes, dust or
overspray. Secure airhose and uid hose wrench tight for safety and
to prevent leaks.
12. 27SC 3oz gravity cup assembly
2. HG-09-08 Aircap (05 & 10 also available)
3. HG-10-08 Fluid tip (05 & 10 also available)
6. HG-11-08 Needle (05 & 10 also available)
A. trigger stroke adjustment knob
B. Fan pattern adjustment knob
C. Air hose attachment inlet (1/4” NPT)
Cleaning:
After each use,spray your paint solvent through the spray gun and
wipe off the outside with clean solvent. Never leave the entire spray
gun immersed in solvent. Dirty air caps and tips should be cleaned
by soaking in solvent and then blown clean with air. Personal safety
equipment should be used at all times.
CAUTION: WHEN CLEANING SPRAY GUN BE AWARE THAT SOME O-RINGS
ARE NOT SOLVENT PROOF AND COULD BE DAMAGED BY CERTAIN
CLEANING SOLVENTS.
Diagram and spare parts:

3

4