Panasonic SN-GCJA5L User manual

LASER TYPE
PARTICULATE MATTER (PM) SENSOR
SN-GCJA5L
Evaluation Kit Instruction Manual
na.industrial.panasonic.com/laser-type-pm-sensor-eval-kit

ITEMS NEEDED FOR EVALUATION:
Panasonic Laser PM Sensor
And Lead Wire With Connector
Software For
Arduino Uno
Software For
Arduino Uno
Software For
PC application
Arduino IDE (Driver)
https://www.arduino.cc/en/Main/Software
u
u
w x
v w
y
BOB-12009 Bidirectional I2C
Voltage Level Shifter Using FET
WIRING AND CONNECTION TO ARDUINO®UNO
BOB-12009
Bidirectional I2C Voltage
Level Shifter Using FET Switch Science
Arduino UNO Board
Switch Science
Arduino UNO Board
v
JST Connector
SHR-05V-S
*NC(blue lead) is NA
*Recommended Lead Wire AWG26
VDD
GND
SCL
SDA
NC

z
TEST BOARD SETUP MANUAL
yx
Software For PC Application
PM25TestChecker
180702.zip
PM25TestChecker
180702.zip
Arduino Drivers
PM25TestChecker
180702
PM25TestChecker
180702.exe
Arduino Drivers
PM25TestChecker
180702.exe
WIRING AND CONNECTION TO ARDUINO UNO (CONT.)
1 Unzip "PM25TestChecker180702.zip"
2 In the “PM25TestChecker180702”, there are “Arduino Drivers” folder and "PM25TestChecker180702.exe" folder.
• "Arduino Drivers" folder is for (Arduino Uno board’s driver install).
• "PM25TestChecker180702.exe" is for (how to get the data with Arduino Uno board)

TEST BOARD DRIVER INSTALL
1 Connect Arduino Uno board to Windows PC by USB cable. The PC Windows version should be Windows7.
2 Install the driver automatically. (If install fails, go to number 3).
3 Start the device manager.
4 If display ”Unknown device”, click this file.
If nothing, right-click the Arduino like icon inside ”port (COM and LPT)” and click software update.
5 Select ”refer the driver software on this computer”.
6 Select the “Arduino Drivers” folder. Check to “search sub folder also” and next.
7 Finish the install and confirm there is “Arduino UNO” on the port (COM and LPT). Note the port number.
8 If “Arduino Uno” not shown, please try again.

1 Make a copy “PM25TestChecker180702.exe” on PC.
2 Connect the Arduino Uno board and sensor by the connector.
3 Click and start “PM25TestChecker180702.exe”.
4 Under “COM Port” please click on “COMM Search.
5 Otherwise click on “COMM Search.
6 Click on “START” and begin measuring.
7 Click on “STOP” to stop measuring.
8 Click on “SAVE LOG” to save data
* Interval time is fixed
w
y
x
{ |
*
DATA RETRIEVAL
INSTRUCTIONS FOR PM2.5 MONITORING
Number of measurement
Log data
PM1.0 mass-density value
PM2.5 mass-density value
PM10 mass-density value
Interval time is fixed
Stop Measurement
Clear Log Save Log
PM25TestChecker
180702.exe