Panasonic VARICAM LT User manual

Top
＞ Preparation ＞ Mounting the module ＞ Mounting the shoulder mount module
Mounting the shoulder mount module
1Release the fixing by turning the slide rail lock knob anticlockwise. (Fig. 1)
The angle of the slide rail lock knob can be changed by turning while pulling forward.
Operating Guide VariCam LT

2Remove the slide rail from the shoulder mount module while pressing the stopper to the direction
indicated by the arrow. (Fig. 2)
3Orient the stopper opening of the slide rail toward the front of the camera, and securely mount to
the bottom of the camera with the supplied two screws on the screw holes indicated in the figure.
(Fig. 3)
4Slide the camera forward along the groove in the shoulder mount module from the rear until it clicks.
(Fig. 4)
Before mounting, con fi rm that the slide rail lock knob is released.
5Adjusting the slide position of the camera considering its weight balance, and lock by turning the
slide rail lock knob clockwise. (Fig. 1)
Con fi rm that the camera is securely locked. The camera may fall causing a malfunction or injury when the camera is
o ff balance or the screws are not locked securely.
Disassembling
1Release the fixing by turning the slide rail lock knob anticlockwise. (Fig. 1)
The angle of the slide rail lock knob can be changed by turning while pulling forward.
2Remove the camera from the shoulder mount module by sliding the camera toward rear while
pressing the stopper to the direction indicated by the arrow (Fig. 2). (Fig. 4)
If the shoulder mount is mounted on a tripod, lock the pan lock lever and the tilt lock lever of the tripod. It may lose
balance and fall, causing a malfunction or injury.
3Loosen the two screws and remove the slide rail from the bottom of the camera. (Fig. 3)
▶ About this manual
Published: March 2019
© 2016 Panasonic Corporation W0316HM8039 -YI
VQT5M58A-8(E)