Panasonic VL-GT001A User manual

Desktop Stand
Installation Guide
Model No. VL-GT001A
How to install the desktop stand
Important:
LThis unit is connected to the power cord and wires, therefore do not change the
installation position frequently. This could cause the power cord and wires to
disconnect.
Overview
Front Side
Bottom
Wrap the excess wire as shown.
Power cable
clamp
145 mm (5
11
/
16
")
157 mm (6
3
/
16
")
105°
160 mm (6
5
/
16
")
Wire
PFQX2167ZA DC0405NK0
GT001A.fm Page 3 Thursday, March 10, 2005 12:32 PM

Installation
1Install the mounting bracket of the monitor station using the wood screws (4 mm × 16 mm,
3/16" × 5/8") to the holes.
LRemove the mounting bracket and wood screws from the rear of the monitor station
beforehand.
2Run the wires from the door station through the unit, then to the monitor station.
3Run the power cable through the unit and the power cable clamp.
4Mount the monitor station to the mounting bracket, and push down until it is secure.
Technical data about this product
Dimensions: Approximately height 157 mm × width 145 mm × depth 160 mm
(63/16" × 511/16" × 65/16")
Mass (Weight): Approximately 180 g (0.39 lb.)
Installation method: Desktop type
External material: ABS resin
Desktop stand
Power cable
Mounting bracket
Wire
Power cable clamp
Wood screws
GT001A.fm Page 4 Thursday, March 10, 2005 12:32 PM