Panasonic FV-24JR2 User manual

4
5
12
13
13
FV-24JR2FV-24JA2
VentilatingFan
INSTALLATION AND OPERATIONG INSTRUCTIONS

WARNING
WARNING
CAUTION

WARNING
Suggest using 60227 IEC 53(RW) ordinary polyvinyl chloride sheathed cord. Nominal cross-sectional area of conductors
is 3×0.75mm² (suited for FV-24JR2) or 4×0.75mm² (suited for FV-24JA2).
It may cause damage to the product or a fire may be caused.
> 2.3

CAUTION

WARNING
Please wear gloves during the installation.

Loosen the terminal box cover screws (2 pcs) and cord clip screws (2 pcs), connect the power cord to the wiring
terminal block according to wiring methods below. (The detailed wiring methods please refer to wiring diagram page 8.)
CAUTION
Screws
(2 pcs) Screws
(2 pcs)
Cord clip
Screwdriver
Power cord
(not supplied)
Wiring box cover

Cord clip
Cord clip
Green
Green
Brown
Brown
Black
Live (L)
Live (L)
Signal wire
Neutral (N)
Neutral (N)
(Green/yellow)
earth ground(G)
(Green/yellow)
earth ground(G)
ground(G)
(Green/yellow)
earth
ground(G)
(Green/yellow)
earth
Green/yellow
Green/yellow
Blue
Blue
Wiring terminal
block
Wiring terminal
block
Power cord
(not supplied)
Power cord
(not supplied)
Put the power cord into the terminal box before wiring.
Be sure the screws of wiring box cover are tightened firmly.
This may cause electric shock.
For the stripping length, please according to the wiring sketch (refer to above figure ). If the stripping length is too
long, it may cause short circuit.
Do not damage the sheath of the power cord.
Strand the core wire together into a bundle, then insert them into the deep position of the terminal block, ensuring that the
screw terminal column of wiring terminal block is pressed on copper and no copper core cord is exposed outside. Otherwise a
short an electric shock may be caused.circuit or
Tighten the wiring screw, and confirm all the wires are fixed reliably .
After wiring, fix the power cord with cord clip reliably, then put the cover back on and fix by screws wiring box
reliably (2 pcs).
WARNING

25 30mm