Panasonic PT-D12000 User manual

PT-D12000/PT-DZ12000 Operating Instructions
Additions and Corrections to the Operating Instructions
Installation in a downward vertical position
■
When installing the projector in a downward vertical position, please ensure to attach the supplied fittings to all lamp units.
Without the fittings, the lamp life may be shortened.
When installing the projector other than in a downward vertical position, remove the fittings.
Range of the downward vertical position1.
Downward vertical position range:
45° forward and backward from the
position perpendicular to the ceiling.
45°
45°
How to attach the fitting to the lamp unit2.
ARemove the lamp unit from the projector, following the “Procedure of lamp unit replacement” (Page 115) of
the Operating Instructions.
BInsert the fitting into the gap between the plastic holder and the wire mesh as shown in the figure below.
∗Leave no gap between the fitting and the wire mesh.
Insert fitting between plastic
holder and wire mesh.
Plastic holder
Fitting
CInstall the lamp unit into the projector, following the “Procedure of lamp unit replacement” (Page 115) of
the Operating Instructions.
Changes in the table in page 21 of the Operating Instructions
■
±5 1.6 3.2 0.8
±5 1.2 2.4 0.6
±10 0.8 1.6 0.4
±15 0.6 1.0 0.3
±5 3.0 6.0 1.5 3.0
±5 2.4 4.8 1.2 2.4
±15 0.4 0.8 0.2
D12000 DZ12000
ET-D75LE1
±40 ±15 ±5
ET-D75LE2
±40 ±15 ±5
ET-D75LE3
±40 ±15 ±10
ET-D75LE4
±40 ±15 ±10
ET-D75LE5
±22 ±15 ±5
ET-D75LE6
±28 ±10 ±5
ET-D75LE8
±40 ±15 ±10
1.6
1.2
0.8
0.5
0.4
4.3
2.6
Lens
Keystone correction only When using arc and keystone correction together Arc correction only
Vertical
Keystone
Correction
Angle α(°)
Horizontal
Keystone
Correction
Angle β(°)
Vertical
Keystone
Correction
Angle α(°)
Horizontal
Keystone
Correction
Angle β(°)
R2/L2
minimum
value
R3/L3
minimum
value
R2/L2
minimum
value
R3/L3 minimum value
∗
∗
∗For DZ12000, the above value changes apply. P0908-0A