Panasonic CZ-RTC2 Parts list manual

Basic Functions of theCZ-RTC2Remote Controller
1. Start/Stop Button:
Pushing this button starts and pushing again stops the unit.
2. Operation Lamp:
This lamp is turned on when the air conditioner is in operation. This lamp blinks
when an error occurs or a protective device has activated.
Operation lamp Start / Stop Button
3. Mode select button:
Push this button to select an operation mode .Each time the Mode Select Button is
pressed it cycles through all the available modes. In this example the mode is set to
Auto.(If applicable to your system).
Auto Mode: Automatically sets the system to heating or cooling for single split
systems (Heat P ump models only).
Auto Mode Icon
Mode select Button

Heating Mode: This mode is used for normal heating operation.
Standby: For several minutes after the start of heating operation the indoor
fan will not start running(or at very low speed) until the indoor heat
exchanger has warmed up sufficiently. This prevents a cold air draft from
entering the space. During this period the Standbyicon remains displayed.
Standb
y
Icon
Heatin
g
Mode Icon
Mode select Button
Cooling Mode: Used for normal cooling operation
Coolin
g
Mode Icon
Mode select Button
Fan Mode: Used to run fan only without heating or cooling operation.
Fan Mode Icon
Mode select Button

Dry Mode: During the Dry operation the system adjusts the room
temperature and the fan speed automatically according to the conditions in
the room, in order to maintain a comfortable room environment.
Dr
y
Mode Icon
Note: There is no humidity sensor in the indoor unit. The system
automatically controls the compressor and indoor fan. The system will
decrease in output as it gets close to set-point but may over shoot the set-
point by a few degrees to control room humidity. Dry mode operation is not
possible if the outdoor temperature is 59 degrees or less.
4. Temperature Setting Buttons:
These buttons are used to set the desired temperature (Set-Point).The Up
arrow raises the set-point and the Down arrow lowers the set-point
Temperature
Setting Buttons

5. Fan Speed Button:
Use this button to adjust the fan speed between Auto, High, Medium and
Low speed. Each time the Fan Speed Button is pressed will cycle it through
the available speeds.
Auto mode: The air conditioner will automatically decide on the fan speed
according to the room temperature conditions.
Auto
Fan Speed Button
High
Medium
Low
Note: When the Low speed is selected and the air conditioner is in cooling
mode at a low outdoor temperature of less than 50 degrees, the air
conditioner may automatically switch to Medium fan speed.

6. Swing/Air Direction Button:
This button adjusts the swing direction to the flap (If Applicable) on the
indoor unit. The air direction can be adjusted to a fixed position or set to
auto to “sweep” continuously.
Swing/Air
Direction Button
Note: The flap is directed up during the heat Standby. The flap starts
swinging after the heat Standby is canceled, although the Auto flap
indication on the remote control unit is displayed during the heat Standby
mode.
In the Cool and Dry mode, when the flaps are set in a downward position,
condensation may form and drip around the vent. Some flap positions are
not available in different modes to avoid dripping or overheating of the unit.
Cool or Dry- 3 positions
Heat or Fan- 5 positions
Auto- Cooling- 3 positions, Heating- 5 positions
Do not move the flap with your hands. If the flap position has been
manually moved then turn the unit off, then back on and the position will be
automatically re-set.