Panduit CT-1104 Instruction Manual

© Panduit Corp. 2014
Page: 1 of 2
E-mail:
[e-mail]
For echnical Support:
1-888-506-5400, ext. 83255
C -1123 and C -1104
PA25121A01
REV: 02 10-2014
CON ROLLED CYCLE FERRULE CRIMPING OOLS
OPERA ION, INSPEC ION and MAIN ENANCE INS RUC IONS
1. With the handles in the open position, insert the ferrule
into the crimp pocket. Make sure that the ferrule is
inserted fully into the crimp die (see Figure 2). Close
handles until dies just slightly grip ferrule.
2. Insert the stripped wire into the ferrule until the wire
stops. Refer to ferrule packaging for wire strip length.
3. Crimp the ferrule by closing the handles until the
controlled cycle mechanism releases. pon release,
the handles will open automatically and the crimped
ferrule can be removed.
NO E: Crimp entire uninsulated ferrule length. This may
require additional crimps.
C -1123 and C -1104 OOLS
Cushioned handle grips
Self-adjusting crimp die
for Insulated and non-
insulated ferrules.
Ferrule size dependent on
wire gage.
Refer to ferrule packaging
for proper ferrule and wire
combinations.
Controlled cycle
mechanism prevents tool
from opening before
crimp cycle is
complete.
Fig. 1
Fig. 2
Stripped
Wire Crimp Die
Ferrule
CAUTION:
Verify power is “OFF” before working on
wiring with these tools.
The plastic grips are for the user’s
comfort, and are not intended
to insulate against electrical shock while
working on li e electrical circuits.
C -1123 ool
(CT-1104 Tool not shown)
Manual release lever,
push forward in the event
that controlled cycle
mechanism must be
released.
www.panduit.com

Page: 2 of 2
NEW OOLS - BEFORE PLACING IN O SERVICE:
All Panduit crimping tools are inspected before they are shipped from the factory. All new tools should be inspected
before being used.
New tools are shipped, factory lubricated, in protective packaging. After inspection, simply clean any excess oil from the
crimping dies and place into service.
When the tool is not in use, keep the handles closed to prevent objects from becoming lodged in the crimping area. Store
the tool in a clean, dry area.
IN SERVICE OOLS - AF ER OOLS HAVE BEEN IN SERVICE:
It is recommended that each operator of the tool be made aware of - and responsible for following these maintenance
steps:
In-service tools should be cleaned and inspected at least ONCE A MONTH. To clean - wipe with a clean cloth.
In-service tools should be lubricated ONCE A WEEK, and after every cleaning. Lubricate all pins, pivots and bearing
surfaces with DOW CORNING®Molykote BR2 Plus.
Be sure to clean any excess oil from the crimping dies before using.
®Molykote BR2 Plus is the Registered Trademark of DOW CORNING.
INSPEC ION / MAIN ENANCE
VISUAL INSPEC ION
© Panduit Corp. 2014 OPERA ION, INSPEC ION
and MAIN ENANCE INS RUC IONS C -1104 & C -1123
1. Visually inspect the tool for missing or loose pins; then close the tool and note the return action of the handles.
2. Inspect the crimping dies for worn, chipped or broken edges.
3. If parts are missing, defective or damaged; contact Panduit for information on repair or replacement of tools.
4. Check for debris in dies. Any debris will need to be removed prior to tool use.